On Fri, Jun 09, 2017 at 01:43:45PM +0200, Geert Uytterhoeven wrote: > Hi Simon, Magnus, > > The Renesas Salvator-XS (Salvator-X 2nd version) development board can > be equipped with either an R-Car H3 ES2.0 or M3-W ES1.x SiP, which are > pin-compatible. > > This patch series adds initial support for the Renesas Salvator-XS > development board equipped with an R-Car H3 ES2.0 SiP. The support > level is similar to the existing support for Salvator-X with the same > SiP. See below for exceptions. > > The Salvator-XS board is similar but not identical to the already > supported Salvator-X board. To avoid duplication, the common parts are > extracted first into its own .dtsi file. > Noteworthy differences are: > - The main clock crystal ticks at a slightly different rate. > - On R-Car H3 ES2.0, SATA no longer uses dedicated pins, but shares > them with the second PCIe channel. To cater for this, a MAX4888B > multiplexer has been added to Salvator-XS. As the default hardware > configuration enables PCIe, I disabled SATA. > - The Versaclock5 clock generator has been replaced by a similar > member of the Versaclock6 family. As the latter is not supported by > Linux yet, I left it out. > - The USB3.0 micro-B connector is replaced by a USB2.0 micro-AB > connector (both are not yet supported, so no change is needed now). > > Dependencies: > - renesas-devel-20170608-v4.12-rc4, > - "arm64: dts: salvator-x: Add missing index to PWM pinctrl subnode > name". > > For your convenience, I've pushed this series, its dependencies, and a > few related driver changes to the topic/r8a7795-salvator-xs branch of > the git repository at > https://git.kernel.org/cgit/linux/kernel/git/geert/renesas-drivers.git > > This has been tested on Salvator-XS with R-Car H3 ES2.0, and Salvator-X > with R-Car H3 ES1.0. > > Thanks! Thanks, I have queued this up for v4.13.
