On 24/03/17 15:28, Jacopo Mondi wrote:
> Add device tree bindings documentation for Maxim max9611/max9612 current
> sense amplifier.
>
> Signed-off-by: Jacopo Mondi <jacopo+renesas@xxxxxxxxxx>
Fine with me, waiting for Mark or Rob to take a look though....
> ---
> .../devicetree/bindings/iio/adc/max9611.txt | 26 ++++++++++++++++++++++
> 1 file changed, 26 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/iio/adc/max9611.txt
>
> diff --git a/Documentation/devicetree/bindings/iio/adc/max9611.txt b/Documentation/devicetree/bindings/iio/adc/max9611.txt
> new file mode 100644
> index 0000000..8430d3b
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/iio/adc/max9611.txt
> @@ -0,0 +1,26 @@
> +* Maxim max9611/max9612 current sense amplifier with 12-bits ADC interface
> +
> +Maxim max9611/max9612 is an high-side current sense amplifier with integrated
> +12-bits ADC communicating over I2c bus.
> +The device node for this driver shall be a child of a I2c controller.
> +
> +Required properties
> + - compatible: Should be "maxim,max9611" or "maxim,max9612"
> + - reg: The 7-bits long I2c address of the device
> + - shunt-resistor-uohm: Value, in uOhm, of the current sense shunt resistor
I'm fine with this being generic, but it makes this just non trivial enough that
I'll wait for Rob or Mark to have a chance to take a look at the binding.
> +
> +Example:
> +
> +&i2c4 {
> + csa: adc@7c {
> + compatible = "maxim,max9611";
> + reg = <0x7c>;
> +
> + shunt-resistor-uohm = <5000>;
> + };
> +};
> +
> +This device node describes a current sense amplifier sitting on I2c4 bus
> +with address 0x7c (read address is 0xf9, write address is 0xf8).
> +A sense resistor of 0,005 Ohm is installed between RS+ and RS- current-sensing
> +inputs.
>
