Hello!
On 01/27/2017 02:04 PM, Simon Horman wrote:
From: Kazuya Mizuguchi <kazuya.mizuguchi.ks@xxxxxxxxxxx>
This patch enables tx and rx clock internal delay modes (TDM and RDM).
This is to address a failure in the case of 1Gbps communication using the
by salvator-x board with the KSZ9031RNX phy. This has been reported to
occur with both the r8a7795 (H3) and r8a7796 (M3-W) SoCs.
With this change APSR internal delay modes are enabled for
"rgmii-id", "rgmii-rxid" and "rgmii-txid" phy modes as follows:
phy mode | ASPR delay mode
-----------+----------------
rgmii-id | TDM and RDM
rgmii-rxid | RDM
rgmii-txid | TDM
Signed-off-by: Kazuya Mizuguchi <kazuya.mizuguchi.ks@xxxxxxxxxxx>
Signed-off-by: Simon Horman <horms+renesas@xxxxxxxxxxxx>
---
v1 [Simon Horman]
- Combined patches
- Reworded changelog
v0 [Kazuya Mizuguchi]
---
drivers/net/ethernet/renesas/ravb.h | 10 ++++++++++
drivers/net/ethernet/renesas/ravb_main.c | 29 +++++++++++++++++++++++++++++
2 files changed, 39 insertions(+)
diff --git a/drivers/net/ethernet/renesas/ravb.h b/drivers/net/ethernet/renesas/ravb.h
index f1109661a533..d7c91d48cc48 100644
--- a/drivers/net/ethernet/renesas/ravb.h
+++ b/drivers/net/ethernet/renesas/ravb.h
[...]
@@ -248,6 +249,15 @@ enum ESR_BIT {
ESR_EIL = 0x00001000,
};
+/* APSR */
+enum APSR_BIT {
+ APSR_MEMS = 0x00000002,
Not documented in the revision 0.5 of the gen3 manual...
+ APSR_CMSW = 0x00000010,
+ APSR_DM = 0x00006000,
... and neither this field. Are these documented in the latter revs?
+ APSR_DM_RDM = 0x00002000,
+ APSR_DM_TDM = 0x00004000,
+};
+
/* RCR */
enum RCR_BIT {
RCR_EFFS = 0x00000001,
diff --git a/drivers/net/ethernet/renesas/ravb_main.c b/drivers/net/ethernet/renesas/ravb_main.c
index 89ac1e3f6175..9fb4c04c5885 100644
--- a/drivers/net/ethernet/renesas/ravb_main.c
+++ b/drivers/net/ethernet/renesas/ravb_main.c
@@ -1904,6 +1904,29 @@ static void ravb_set_config_mode(struct net_device *ndev)
}
}
+static void ravb_set_delay_mode(struct net_device *ndev)
+{
+ struct ravb_private *priv = netdev_priv(ndev);
+
+ if (priv->chip_id != RCAR_GEN2) {
+ switch (priv->phy_interface) {
+ case PHY_INTERFACE_MODE_RGMII_ID:
+ ravb_modify(ndev, APSR, APSR_DM, APSR_DM_RDM |
+ APSR_DM_TDM);
+ break;
+ case PHY_INTERFACE_MODE_RGMII_RXID:
+ ravb_modify(ndev, APSR, APSR_DM, APSR_DM_RDM);
+ break;
+ case PHY_INTERFACE_MODE_RGMII_TXID:
+ ravb_modify(ndev, APSR, APSR_DM, APSR_DM_TDM);
+ break;
+ default:
+ ravb_modify(ndev, APSR, APSR_DM, 0);
+ break;
+ }
How about doing ravb_modify() only once?
[...]
MNR, Sergei
