From: Kieran Bingham <kieran.bingham@xxxxxxxxxxxxxxxx>
Provide a test to verify the hardware completes a functional test whilst
performing a suspend resume cycle in parallel. Make use of the
/sys/power/pm_test functionality provided by CONFIG_PM_DEBUG to perform
the testing
Signed-off-by: Kieran Bingham <kieran.bingham@xxxxxxxxxxxxxxxx>
---
tests/vsp-unit-test-0020.sh | 86 +++++++++++++++++++++++++++++++++++++++++++++
1 file changed, 86 insertions(+)
create mode 100755 tests/vsp-unit-test-0020.sh
diff --git a/tests/vsp-unit-test-0020.sh b/tests/vsp-unit-test-0020.sh
new file mode 100755
index 000000000000..5838295139b2
--- /dev/null
+++ b/tests/vsp-unit-test-0020.sh
@@ -0,0 +1,86 @@
+#!/bin/sh
+
+#
+# Test power-management suspend/resume whilst pipelines are active
+#
+# Utilise the basic RPF->WPF packing test case as a measure that the hardware
+# is operable while we perform test suspend and resume, and verify that it is
+# still successful even with a suspend resume cycle in the middle of the test.
+#
+# Format iteration loops are maintained, even with only one format so that this
+# test can be easily extended to try further formats if needed in the future.
+#
+
+source vsp-lib.sh
+
+features="rpf.0 wpf.0"
+formats="RGB24"
+
+# These can be extracted from /sys/power/pm_test
+suspend_modes="freezer devices platform processors core"
+
+# This extended function performs the same
+# as it's non-extended name-sake - but runs the pipeline
+# for 300 frames. The suspend action occurs between frame #150~#200
+test_extended_wpf_packing() {
+ test_start "Verify WPF packing in $format during suspend:$mode"
+
+ pipe_configure rpf-wpf 0 0
+ format_configure rpf-wpf 0 0 ARGB32 1024x768 $format
+
+ vsp_runner rpf.0 --count=300 &
+ vsp_runner wpf.0 --count=300 --skip=297
+
+ local result=$(compare_frames)
+
+ test_complete $result
+}
+
+test_hw_pipe() {
+ local format
+
+ for format in $formats ; do
+ test_extended_wpf_packing $format
+ done
+}
+
+test_suspend_resume() {
+ local test_results=0
+ local test_pid
+
+ # Test the hardware each side of suspend resume
+ test_hw_pipe &
+ test_pid=$!
+
+ # Make sure the pipeline has time to start
+ sleep 1
+
+ # Set the test mode
+ echo $mode > /sys/power/pm_test
+
+ # Comence suspend
+ # The pm_test framework will automatically resume after 5 seconds
+ echo mem > /sys/power/state
+
+ # Wait for the pipeline to complete
+ wait $test_pid
+}
+
+test_main() {
+ local mode;
+ local suspend_test_failures
+
+ # Check for pm-suspend test option
+ if [ ! -e /sys/power/pm_test ] ; then
+ echo "$0: Suspend Resume testing requires CONFIG_PM_DEBUG"
+ test_complete skip
+ return
+ fi;
+
+ for mode in $suspend_modes ; do
+ test_suspend_resume $mode
+ done;
+}
+
+test_init $0 "$features"
+test_run
--
2.7.4
