Hi Niklas,
On Saturday 01 Oct 2016 11:19:31 Niklas Söderlund wrote:
> On 2016-09-30 16:32:52 +0300, Laurent Pinchart wrote:
> > On Friday 30 Sep 2016 15:00:59 Geert Uytterhoeven wrote:
> >> On Fri, Sep 30, 2016 at 2:40 PM, Laurent Pinchart wrote:
> >>>> --- a/arch/arm/boot/dts/r8a7793-gose.dts
> >>>> +++ b/arch/arm/boot/dts/r8a7793-gose.dts
[snip]
> >>>> @@ -531,6 +536,21 @@
> >>>> };
> >>>> };
> >>>>
> >>>> + hdmi-in@4c {
> >>>> + compatible = "adi,adv7612";
> >>>> + reg = <0x4c>;
> >>>> + interrupt-parent = <&gpio1>;
> >>>> + interrupts = <20 IRQ_TYPE_LEVEL_LOW>;
> >>>
> >>> Isn't the interrupt signal connected to GP4_2 ?
> >>
> >> No idea about Gose, but on Koelsch it is (hence koelsch DTS is wrong??)
> >
> > I believe so. I don't have a Koelsch board anymore so I can't test that.
> > Niklas, do you have a Koelsch on which you could confirm the IRQ number ?
>
> I have done the best I can to prove the IRQ, it proved to be a bit
> tricky or maybe I'm doing it the wrong way.
>
> I hooked up my oscilloscope to EXIO Connector D pin 7, which according
> to the schematics should be GP4_2 and attached to a pull-up at 3.3v. I
> can observe the pull-up and if I control the pin using the
> /sys/class/gpio interface I do indeed control GP4_2, So the schematic is
> correct at least this far.
>
> The trouble I have is that the adv7612 driver do not currently consume
> the interrupt so I can't see multiple field interrupts by observing the
> pin. I do however see what I believe is the first field interrupt, if I
> observe the pin just as I turn on my HDMI video source the pin go from 1
> -> 0 but is never reset and a reset of the entire board is needed if you
> wish to see it again.
>
> If I on the other hand observe pin GP1_20 on EXIO Connector A pin 66 I
> notice nothing on the oscilloscope from that it's set to 3.3V at power
> on, no mater how much HDMI input i run.
>
> In conclusion, yes I do believe the DTS is wrong and that GP4_2 is the
> correct interrupt signal on Koelsch. This adds up with the schematics
> and my rudimentary measurements.
Thanks a lot for testing. Ulrich, could you please fix this patch accordingly
?
--
Regards,
Laurent Pinchart
