All the SHDIs can operate with either 3.3V or 1.8V signals, depending on negotiation with the card. Based on work by Wolfram Sang for the r8a7790. Cc: Wolfram Sang <wsa+renesas@xxxxxxxxxxxxxxxxxxxx> Signed-off-by: Simon Horman <horms+renesas@xxxxxxxxxxxx> --- drivers/pinctrl/sh-pfc/pfc-r8a7791.c | 29 ++++++++++++++++++++++++++++- 1 file changed, 28 insertions(+), 1 deletion(-) diff --git a/drivers/pinctrl/sh-pfc/pfc-r8a7791.c b/drivers/pinctrl/sh-pfc/pfc-r8a7791.c index 0c1a60c9a844..b707fc96f208 100644 --- a/drivers/pinctrl/sh-pfc/pfc-r8a7791.c +++ b/drivers/pinctrl/sh-pfc/pfc-r8a7791.c @@ -13,6 +13,10 @@ #include "sh_pfc.h" +/* + * All pins assigned to GPIO bank 3 can be used for SD interfaces in + * which case they support both 3.3V and 1.8V signalling. + */ #define CPU_ALL_PORT(fn, sfx) \ PORT_GP_32(0, fn, sfx), \ PORT_GP_26(1, fn, sfx), \ @@ -20,7 +24,15 @@ PORT_GP_32(3, fn, sfx), \ PORT_GP_32(4, fn, sfx), \ PORT_GP_32(5, fn, sfx), \ - PORT_GP_32(6, fn, sfx), \ + PORT_GP_CFG_24(6, fn, sfx, SH_PFC_PIN_CFG_IO_VOLTAGE), \ + PORT_GP_1(6, 24, fn, sfx), \ + PORT_GP_1(6, 25, fn, sfx), \ + PORT_GP_1(6, 26, fn, sfx), \ + PORT_GP_1(6, 27, fn, sfx), \ + PORT_GP_1(6, 28, fn, sfx), \ + PORT_GP_1(6, 29, fn, sfx), \ + PORT_GP_1(6, 30, fn, sfx), \ + PORT_GP_1(6, 31, fn, sfx), \ PORT_GP_26(7, fn, sfx) enum { @@ -6404,9 +6416,24 @@ static const struct pinmux_cfg_reg pinmux_config_regs[] = { { }, }; +static int r8a7791_pin_to_pocctrl(struct sh_pfc *pfc, unsigned int pin, u32 *pocctrl) +{ + if (pin < RCAR_GP_PIN(6, 0) || pin > RCAR_GP_PIN(6, 23)) + return -EINVAL; + + *pocctrl = 0xe606008c; + + return 31 - (pin & 0x1f); +} + +static const struct sh_pfc_soc_operations r8a7791_pinmux_ops = { + .pin_to_pocctrl = r8a7791_pin_to_pocctrl, +}; + #ifdef CONFIG_PINCTRL_PFC_R8A7791 const struct sh_pfc_soc_info r8a7791_pinmux_info = { .name = "r8a77910_pfc", + .ops = &r8a7791_pinmux_ops, .unlock_reg = 0xe6060000, /* PMMR */ .function = { PINMUX_FUNCTION_BEGIN, PINMUX_FUNCTION_END }, -- 2.7.0.rc3.207.g0ac5344