On Fri, Jun 24, 2016 at 04:59:14PM +0200, Geert Uytterhoeven wrote: > Make sure the transmitter and receiver are stopped when shutting down > the port, and related interrupts are disabled. > > Without this: > - New input data may be received into the RX FIFO, possibly > triggering a new RX DMA completion, > - Transfers will still be enabled on a subsequent startup of the UART, > before the UART's FIFOs have been reset, causing reading of stale > data. > > Inspired by a patch in the BSP by Koji Matsuoka > <koji.matsuoka.xm@xxxxxxxxxxx>. > > Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx> > --- > v2: > - Do not clear clock source bits, since the serial console relies on > them, as reported by Shimoda-san. > > v1 was extracted from "[PATCH/RFC v3 0/4] serial: sh-sci: Add DT DMA > support". The issues with the serial console seen before on > r8a7740/armadillo and sh73a0/kzm9g seem to be gone. Changes after > resurrection: > - Write zero to also disable related interrupts, as suggested by > Laurent Pinchart, > - Enhanced patch description. > --- > drivers/tty/serial/sh-sci.c | 5 +++++ > 1 file changed, 5 insertions(+) This patch does not apply to my tree :(
