Codethink are publishing the work that they have done for the Renesas 4.2-bsp release for the Renesas RCar-H3. We feel that people could benefit from some or all of the patches that we have been developing. git: http://git.codethink.co.uk/git/public/linux bjdooks/rcar-h3-bsp42/release-01mar2016 We're not going to post all the patches here as they are not for upstream review, and there are a large number of them in the tree. Feeback to linux-kernel@xxxxxxxxxxxxxxxxxxxxx welcome. [Apologies, last email got sent before posting the content for release] Shortlog is: Ben Dooks (59): leds: warn if name is NULL mmcif: attempt to fix host->pio_ptr issues h3 initial defconfig arm: renesas: select PINCTRL for Renesas SoC tmp: reduce blank to 30 seconds vsp1: add check for vsp1_dl_get() return vsp1: check for null pipe set Add release notes salvator-x.dts: add gpio on i2c4 gpio: pca953x: add onsemi,pca9654 id gpio: pca953x: use of_match info if available r8a7795.dtsi: add rt-dmac clock R8A7795_CLK_RTDMAC r8a7795.dtsi: add R8A7795_CLK_SYS_DMAC2 r8a7795.dtsi: add dmac2 node contents r8a7795.dtsi: add rtdmac node h3_defconfig: tidy out some old bits, add i2c-gpio h3_defconfig: add dmatest, remove unused drivers h3_defconfig: updates xhci: add r8a7795 of-id r8a7795.dtsi: add xhci0, xhci1 nodes slavator-x: add xhci node r8a7795: add xhci clocks xhci-rcar: add r8a7795 usb firmware rcar-dmac: add debug/warnings xhci-rcar: add debug to fwdownload codethink: initial test documentation codethink: pwm test documentation salvator-x.dts: add gpiokeys section salvator-x.dts: updated clocks (needed?) tests: update xhci nodes r8a7795.dtsi: put dmac in correct order (needed?) r8a7795.dtsi: add R8A7795_CLK_ADG r8a7795.dtsi: add ADG clock codethink: updated release notes audio: reduce ssi to simple output adg: ensure we can unset SSICKR bit 31 salvator-x.dts: change to make 44.1kHz default base rcar_snd: show if bits set outside of mask value rcar_snd: fix missed use of FORCE bit for SSICR write salvator-x: force audio to use pio (works) codethink: release note update for 22-Dec-2015 arm: show address for WARN_ON() at line 58 pvr: remove memory powervr is trying to ioremap (causing warning) salvator-x: msiof0_sync is audio clock not spi1 pfc-r8a7795: fix issue with MSIOF0 only using GPSR5 pfc-r8a7795: fix missing GPSR pins salvator-x: add hscif0 for bt-uart codethink: updated release notes pfc-r8a7795: fix USB2_OVC definition codethink: updated release notes codethink: updated notes on XHCI tmp: add sg_next to sh_mmcif gpio: gpiod_direction_input -> error if input only? i2c: i2c-rcar: enable pm before adding adapter salvator-x: add i2c2 to pinctrl pfc-r8a7795: add scl3 code slavator-x: i2c3 pinctrl test codethink: updates for release tests: add cpufreq info Jürg Billeter (2): mmc: tmio: fix memory corruption due to out-of-bounds array access phy: rcar-gen3-usb2: do not enable OTG interrupt for non-OTG channels Kejia Hu (7): USB2 phy driver for rcar gen3. HSUSB driver for rcar gen3. arm64: dts: r8a7795: usb2_phy device nodes arm64: dts: r8a7795: add HS-USB device node arm64: dts: salvator-x: add a regulator to be used to handle VBUS on/off for USB2.0 host channel 0. arm64: dts: salvator-x: enable HS-USB kernel config: enable usb2 otg support as a network gadget. Rob Taylor (1): WIP: add dv_timings support to soc_camera William Towle (2): WIP: adv7482_query_dv_timings() dts/i: salv-x bootargs as per 'doboot' cmdline Yoshihiro Shimoda (4): phy: rcar-gen3-usb2: remove HSUSB registers handling usb: renesas_usbhs: add R-Car Gen3 power control phy: rcar-gen3-usb2: Add phy-supply description in device tree doc phy: rcar-gen3-usb2: remove unnecesary struct rcar_gen3_data -- Ben Dooks http://www.codethink.co.uk/ Senior Engineer Codethink - Providing Genius
