Re: [PATCH v3 3/4] remoteproc: qcom_q6v5_pas: Add support to attach a DSP

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, Jun 20, 2024 at 05:31:42PM GMT, Komal Bajaj wrote:
> From: Melody Olvera <quic_molvera@xxxxxxxxxxx>
> 
> Some chipsets will have DSPs which will have begun running prior
> to linux booting, so add support to late attach these DSPs by
> adding support for:
> - run-time checking of an offline or running DSP via rmb register
> - a late attach framework to attach to the running DSP
> - a handshake mechanism to ensure full and proper booting via rmb

I don't fully understand what state we're going to find the remote side
in during this attach.

I think that between commit message and comments in the code it should
be clear what the expected flow is, why there is a 5 second timeout, why
does Linux tell the DSP to "continue boot", etc.

Regards,
Bjorn

> 
> Signed-off-by: Melody Olvera <quic_molvera@xxxxxxxxxxx>
> Signed-off-by: Komal Bajaj <quic_kbajaj@xxxxxxxxxxx>
> ---
>  drivers/remoteproc/qcom_q6v5_pas.c | 102 +++++++++++++++++++++++++++++
>  1 file changed, 102 insertions(+)
> 
> diff --git a/drivers/remoteproc/qcom_q6v5_pas.c b/drivers/remoteproc/qcom_q6v5_pas.c
> index b9759f6b2283..32d45c18e15e 100644
> --- a/drivers/remoteproc/qcom_q6v5_pas.c
> +++ b/drivers/remoteproc/qcom_q6v5_pas.c
> @@ -11,6 +11,7 @@
>  #include <linux/delay.h>
>  #include <linux/firmware.h>
>  #include <linux/interrupt.h>
> +#include <linux/iopoll.h>
>  #include <linux/kernel.h>
>  #include <linux/module.h>
>  #include <linux/of.h>
> @@ -258,6 +259,94 @@ static int adsp_load(struct rproc *rproc, const struct firmware *fw)
>  	return ret;
>  }
> 
> +static int adsp_signal_q6v5(struct qcom_adsp *adsp)
> +{
> +	unsigned int val;
> +	int ret;
> +
> +	if (adsp->q6v5.rmb_base) {
> +		ret = readl_poll_timeout(adsp->q6v5.rmb_base + RMB_BOOT_WAIT_REG,
> +					 val, val, 20000,
> +					 RMB_POLL_MAX_TIMES * 20000);
> +		if (ret < 0)
> +			return ret;
> +
> +		writel_relaxed(1, adsp->q6v5.rmb_base + RMB_BOOT_CONT_REG);
> +	}
> +
> +	return 0;
> +}
> +
> +static int adsp_attach(struct rproc *rproc)
> +{
> +	struct qcom_adsp *adsp = (struct qcom_adsp *)rproc->priv;
> +	int ret;
> +
> +	ret = qcom_q6v5_prepare(&adsp->q6v5);
> +	if (ret)
> +		return ret;
> +
> +	ret = adsp_pds_enable(adsp, adsp->proxy_pds, adsp->proxy_pd_count);
> +	if (ret < 0)
> +		goto disable_irqs;
> +
> +	ret = clk_prepare_enable(adsp->xo);
> +	if (ret)
> +		goto disable_proxy_pds;
> +
> +	ret = clk_prepare_enable(adsp->aggre2_clk);
> +	if (ret)
> +		goto disable_xo_clk;
> +
> +	if (adsp->cx_supply) {
> +		ret = regulator_enable(adsp->cx_supply);
> +		if (ret)
> +			goto disable_aggre2_clk;
> +	}
> +
> +	if (adsp->px_supply) {
> +		ret = regulator_enable(adsp->px_supply);
> +		if (ret)
> +			goto disable_cx_supply;
> +	}
> +
> +	/* if needed, signal Q6 to continute booting */
> +	ret = adsp_signal_q6v5(adsp);
> +	if (ret < 0) {
> +		dev_err(adsp->dev, "Didn't get rmb signal from  %s\n", rproc->name);
> +		goto disable_px_supply;
> +	};
> +
> +	ret = qcom_q6v5_wait_for_start(&adsp->q6v5, msecs_to_jiffies(5000));
> +	if (ret == -ETIMEDOUT) {
> +		dev_err(adsp->dev, "start timed out\n");
> +		qcom_scm_pas_shutdown(adsp->pas_id);
> +		goto disable_px_supply;
> +	}
> +
> +	return 0;
> +
> +disable_px_supply:
> +	if (adsp->px_supply)
> +		regulator_disable(adsp->px_supply);
> +disable_cx_supply:
> +	if (adsp->cx_supply)
> +		regulator_disable(adsp->cx_supply);
> +disable_aggre2_clk:
> +	clk_disable_unprepare(adsp->aggre2_clk);
> +disable_xo_clk:
> +	clk_disable_unprepare(adsp->xo);
> +disable_proxy_pds:
> +	adsp_pds_disable(adsp, adsp->proxy_pds, adsp->proxy_pd_count);
> +disable_irqs:
> +	qcom_q6v5_unprepare(&adsp->q6v5);
> +
> +	/* Remove pointer to the loaded firmware, only valid in adsp_load() & adsp_start() */
> +	adsp->firmware = NULL;
> +
> +	return ret;
> +}
> +
>  static int adsp_start(struct rproc *rproc)
>  {
>  	struct qcom_adsp *adsp = rproc->priv;
> @@ -320,6 +409,13 @@ static int adsp_start(struct rproc *rproc)
>  		goto release_pas_metadata;
>  	}
> 
> +	/* if needed, signal Q6 to continute booting */
> +	ret = adsp_signal_q6v5(adsp);
> +	if (ret < 0) {
> +		dev_err(adsp->dev, "Didn't get rmb signal from  %s\n", rproc->name);
> +		goto release_pas_metadata;
> +	}
> +
>  	ret = qcom_q6v5_wait_for_start(&adsp->q6v5, msecs_to_jiffies(5000));
>  	if (ret == -ETIMEDOUT) {
>  		dev_err(adsp->dev, "start timed out\n");
> @@ -432,6 +528,7 @@ static unsigned long adsp_panic(struct rproc *rproc)
>  static const struct rproc_ops adsp_ops = {
>  	.unprepare = adsp_unprepare,
>  	.start = adsp_start,
> +	.attach = adsp_attach,
>  	.stop = adsp_stop,
>  	.da_to_va = adsp_da_to_va,
>  	.parse_fw = qcom_register_dump_segments,
> @@ -442,6 +539,7 @@ static const struct rproc_ops adsp_ops = {
>  static const struct rproc_ops adsp_minidump_ops = {
>  	.unprepare = adsp_unprepare,
>  	.start = adsp_start,
> +	.attach = adsp_attach,
>  	.stop = adsp_stop,
>  	.da_to_va = adsp_da_to_va,
>  	.parse_fw = qcom_register_dump_segments,
> @@ -779,6 +877,10 @@ static int adsp_probe(struct platform_device *pdev)
>  	if (ret)
>  		goto detach_proxy_pds;
> 
> +	if (adsp->q6v5.rmb_base &&
> +			readl_relaxed(adsp->q6v5.rmb_base + RMB_Q6_BOOT_STATUS_REG))
> +		rproc->state = RPROC_DETACHED;
> +
>  	qcom_add_glink_subdev(rproc, &adsp->glink_subdev, desc->ssr_name);
>  	qcom_add_smd_subdev(rproc, &adsp->smd_subdev);
>  	adsp->sysmon = qcom_add_sysmon_subdev(rproc,
> --
> 2.42.0
> 




[Index of Archives]     [Linux Sound]     [ALSA Users]     [ALSA Devel]     [Linux Audio Users]     [Linux Media]     [Kernel]     [Photo Sharing]     [Gimp]     [Yosemite News]     [Linux Media]

  Powered by Linux