Make the driver use qcom_fw_helper to autodetect the path to the
calibration data file.
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
---
drivers/remoteproc/qcom_wcnss.c | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/drivers/remoteproc/qcom_wcnss.c b/drivers/remoteproc/qcom_wcnss.c
index 421a3943a90d..45fc578ae30b 100644
--- a/drivers/remoteproc/qcom_wcnss.c
+++ b/drivers/remoteproc/qcom_wcnss.c
@@ -23,6 +23,7 @@
#include <linux/regulator/consumer.h>
#include <linux/remoteproc.h>
#include <linux/soc/qcom/mdt_loader.h>
+#include <linux/soc/qcom/fw_helper.h>
#include <linux/soc/qcom/smem.h>
#include <linux/soc/qcom/smem_state.h>
@@ -555,8 +556,13 @@ static int wcnss_probe(struct platform_device *pdev)
if (ret < 0 && ret != -EINVAL)
return ret;
+ fw_name = qcom_get_board_fw(fw_name);
+ if (!fw_name)
+ return -ENOMEM;
+
rproc = devm_rproc_alloc(&pdev->dev, pdev->name, &wcnss_ops,
fw_name, sizeof(*wcnss));
+ kfree(fw_name);
if (!rproc) {
dev_err(&pdev->dev, "unable to allocate remoteproc\n");
return -ENOMEM;
--
2.39.2
