The "smd-edge"s for remote processors are typically specified below the remoteproc nodes. For some reason apq8064 also has them all listed in a top-level /smd node, disabled by default. None of the boards enable them. Right now apq8064 only has support for WCNSS/riva, but there the smd-edge is already defined with the same interrupt etc below the riva-pil node. Drop these redundant definitions since the /smd top-level node is now deprecated. Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx> Signed-off-by: Stephan Gerhold <stephan@xxxxxxxxxxx> --- arch/arm/boot/dts/qcom-apq8064.dtsi | 40 ------------------------------------- 1 file changed, 40 deletions(-) diff --git a/arch/arm/boot/dts/qcom-apq8064.dtsi b/arch/arm/boot/dts/qcom-apq8064.dtsi index d2289205ff81..e0adf237fc5c 100644 --- a/arch/arm/boot/dts/qcom-apq8064.dtsi +++ b/arch/arm/boot/dts/qcom-apq8064.dtsi @@ -226,46 +226,6 @@ smem { hwlocks = <&sfpb_mutex 3>; }; - smd { - compatible = "qcom,smd"; - - modem-edge { - interrupts = <0 37 IRQ_TYPE_EDGE_RISING>; - - qcom,ipc = <&l2cc 8 3>; - qcom,smd-edge = <0>; - - status = "disabled"; - }; - - q6-edge { - interrupts = <0 90 IRQ_TYPE_EDGE_RISING>; - - qcom,ipc = <&l2cc 8 15>; - qcom,smd-edge = <1>; - - status = "disabled"; - }; - - dsps-edge { - interrupts = <0 138 IRQ_TYPE_EDGE_RISING>; - - qcom,ipc = <&sps_sic_non_secure 0x4080 0>; - qcom,smd-edge = <3>; - - status = "disabled"; - }; - - riva-edge { - interrupts = <0 198 IRQ_TYPE_EDGE_RISING>; - - qcom,ipc = <&l2cc 8 25>; - qcom,smd-edge = <6>; - - status = "disabled"; - }; - }; - smsm { compatible = "qcom,smsm"; -- 2.40.1