On 5/8/2023 7:59 PM, Manikanta Mylavarapu wrote:
On 3/7/2023 8:49 PM, Krzysztof Kozlowski wrote:
On 07/03/2023 05:41, Manikanta Mylavarapu wrote:
Add support for the QDSP6 gcc clock control used on IPQ9574
based devices. This would allow mpd remoteproc driver to control
the required gcc clocks to bring the subsystem out of reset.
Signed-off-by: Manikanta Mylavarapu <quic_mmanikan@xxxxxxxxxxx>
---
include/dt-bindings/clock/qcom,ipq9574-gcc.h | 159 ++++++++++---------
1 file changed, 83 insertions(+), 76 deletions(-)
diff --git a/include/dt-bindings/clock/qcom,ipq9574-gcc.h
b/include/dt-bindings/clock/qcom,ipq9574-gcc.h
index c89e96d568c6..8bd6350ecd56 100644
--- a/include/dt-bindings/clock/qcom,ipq9574-gcc.h
+++ b/include/dt-bindings/clock/qcom,ipq9574-gcc.h
@@ -138,80 +138,87 @@
#define WCSS_AHB_CLK_SRC 129
#define GCC_Q6_AHB_CLK 130
#define GCC_Q6_AHB_S_CLK 131
-#define GCC_WCSS_ECAHB_CLK 132
-#define GCC_WCSS_ACMT_CLK 133
That's an ABI break, if file was accepted. Or a very weird change
anyway, if it wasn't (why adding entry and immediately changing it?).
Best regards,
Krzysztof
I will add new macros at the end instead in middle.
Thanks & Regards,
Manikanta.
Clocks in multipd architecture will be handled by QDSP6 firmware.
So i am going to remove clock macros and drop this patch.
Thanks & Regards,
Manikanta.
