From: Peng Fan <peng.fan@xxxxxxx> ENABLE_M4 should be set to 1 when loading code to TCM, otherwise you will not able to replace the firmware after you stop m4. Besides ENABLE_M4, we still need set SW_M4C_RST, because this bit will be automatically set with SW_M4C_NON_SCLR_RST set. Signed-off-by: Peng Fan <peng.fan@xxxxxxx> --- V1: Although this is an fix, but it is not critical, patch is based on https://patchwork.kernel.org/project/linux-remoteproc/cover/1620274123-1461-1-git-send-email-peng.fan@xxxxxxxxxxx/ drivers/remoteproc/imx_rproc.c | 8 +++++--- 1 file changed, 5 insertions(+), 3 deletions(-) diff --git a/drivers/remoteproc/imx_rproc.c b/drivers/remoteproc/imx_rproc.c index cd2ca96a30e5..ce2ce42bee91 100644 --- a/drivers/remoteproc/imx_rproc.c +++ b/drivers/remoteproc/imx_rproc.c @@ -33,7 +33,8 @@ #define IMX7D_M4_START (IMX7D_ENABLE_M4 | IMX7D_SW_M4P_RST \ | IMX7D_SW_M4C_RST) -#define IMX7D_M4_STOP (IMX7D_ENABLE_M4 | IMX7D_SW_M4C_NON_SCLR_RST) +#define IMX7D_M4_STOP (IMX7D_ENABLE_M4 | IMX7D_SW_M4C_RST | \ + IMX7D_SW_M4C_NON_SCLR_RST) /* Address: 0x020D8000 */ #define IMX6SX_SRC_SCR 0x00 @@ -44,7 +45,8 @@ #define IMX6SX_M4_START (IMX6SX_ENABLE_M4 | IMX6SX_SW_M4P_RST \ | IMX6SX_SW_M4C_RST) -#define IMX6SX_M4_STOP (IMX6SX_ENABLE_M4 | IMX6SX_SW_M4C_NON_SCLR_RST) +#define IMX6SX_M4_STOP (IMX6SX_ENABLE_M4 | IMX6SX_SW_M4C_RST | \ + IMX6SX_SW_M4C_NON_SCLR_RST) #define IMX6SX_M4_RST_MASK (IMX6SX_ENABLE_M4 | IMX6SX_SW_M4P_RST \ | IMX6SX_SW_M4C_NON_SCLR_RST \ | IMX6SX_SW_M4C_RST) @@ -691,7 +693,7 @@ static int imx_rproc_detect_mode(struct imx_rproc *priv) return ret; } - if (!(val & dcfg->src_stop)) + if ((val & dcfg->src_mask) != dcfg->src_stop) priv->rproc->state = RPROC_DETACHED; return 0; -- 2.30.0
