> Subject: Re: [PATCH 2/2] remoteproc: use filesz as backup when translate
> memsz fail
>
> On Thu, Apr 09, 2020 at 06:22:26PM -0700, Bjorn Andersson wrote:
> > On Thu 09 Apr 01:22 PDT 2020, Peng Fan wrote:
> >
> > > Since we no need memset if memsz is larger than filesz, we could use
> > > filesz for the da to va translation when memsz translation fail.
> > >
> >
> > To me this implies that the firmware has a segment that's larger than
> > the memory that it's going to run in. I think even if we're not
> > writing to the entire memsz, asking da_to_va for the entire memsz
> > provides a valuable sanity check.
> >
> > Regards,
> > Bjorn
> >
> > > Signed-off-by: Peng Fan <peng.fan@xxxxxxx>
> > > ---
> > > drivers/remoteproc/remoteproc_elf_loader.c | 12 ++++++++++--
> > > 1 file changed, 10 insertions(+), 2 deletions(-)
> > >
> > > diff --git a/drivers/remoteproc/remoteproc_elf_loader.c
> > > b/drivers/remoteproc/remoteproc_elf_loader.c
> > > index cc50fe70d50c..74d425a4b34c 100644
> > > --- a/drivers/remoteproc/remoteproc_elf_loader.c
> > > +++ b/drivers/remoteproc/remoteproc_elf_loader.c
> > > @@ -229,8 +229,16 @@ int rproc_elf_load_segments(struct rproc *rproc,
> const struct firmware *fw)
> > > if (!ptr) {
> > > dev_err(dev, "bad phdr da 0x%llx mem 0x%llx\n", da,
> > > memsz);
> > > - ret = -EINVAL;
> > > - break;
> > > +
> > > + ptr = rproc_da_to_va(rproc, da, filesz);
> > > + if (!ptr) {
> > > + dev_err(dev,
> > > + "bad phdr da 0x%llx mem 0x%llx\n",
> > > + da, filesz);
> > > + ret = -EINVAL;
> > > + break;
> > > + }
> > > +
>
> Adding to Bjorn's comment, I think if rproc_da_to_va() fails with memsz but
> succeeds with filesz something went wrong with how memory was laid out in
> the DT or the ELF resources. To me this patch offers the wrong solution - the
> focus should be on why rproc_da_to_va() fails.
ok, I'll send out patch to fix imx_rproc. It is TCML and TCMU are not mapped continusly.
Thanks,
Peng.
>
> Thanks,
> Mathieu
>
> > > }
> > >
> > > /* put the segment where the remote processor expects it */
> > > --
> > > 2.16.4
> > >
