From: Rafi Wiener <rafiw@xxxxxxxxxxxx>
Before QP is closed it changes to ERROR state, when this happens
the QP was left with old rate limit that was already removed from
the table.
Fixes: 7d29f349a4b9 ("IB/mlx5: Properly adjust rate limit on QP state transitions")
Signed-off-by: Rafi Wiener <rafiw@xxxxxxxxxxxx>
Signed-off-by: Oleg Kuporosov <olegk@xxxxxxxxxxxx>
Signed-off-by: Leon Romanovsky <leonro@xxxxxxxxxxxx>
---
drivers/infiniband/hw/mlx5/qp.c | 8 +++++---
1 file changed, 5 insertions(+), 3 deletions(-)
diff --git a/drivers/infiniband/hw/mlx5/qp.c b/drivers/infiniband/hw/mlx5/qp.c
index 8937d72ddcf6..5fd071c05944 100644
--- a/drivers/infiniband/hw/mlx5/qp.c
+++ b/drivers/infiniband/hw/mlx5/qp.c
@@ -3249,10 +3249,12 @@ static int modify_raw_packet_qp_sq(
}
/* Only remove the old rate after new rate was set */
- if ((old_rl.rate &&
- !mlx5_rl_are_equal(&old_rl, &new_rl)) ||
- (new_state != MLX5_SQC_STATE_RDY))
+ if ((old_rl.rate && !mlx5_rl_are_equal(&old_rl, &new_rl)) ||
+ (new_state != MLX5_SQC_STATE_RDY)) {
mlx5_rl_remove_rate(dev, &old_rl);
+ if (new_state != MLX5_SQC_STATE_RDY)
+ memset(&new_rl, 0, sizeof(new_rl));
+ }
ibqp->rl = new_rl;
sq->state = new_state;
--
2.20.1
