On Tue, Dec 19, 2017 at 11:14:03PM +0530, Selvin Xavier wrote:
> On Tue, Dec 19, 2017 at 6:00 PM, Leon Romanovsky <leon@xxxxxxxxxx> wrote:
> >> status = ocrdma_nonemb_mbx_cmd(dev, mqe, dev->stats_mem.va);
> >
> > It still doesn't make a lot of sense to me:
> >
> > ocrdma_mbx_rdma_stats():
> > 1315 if (reset)
> > 1316 req->reset_stats = reset;
> > 1317
> > 1318 status = ocrdma_nonemb_mbx_cmd(dev, mqe, dev->stats_mem.va);
> >
> >
> > 1117 static int ocrdma_nonemb_mbx_cmd(struct ocrdma_dev *dev, struct ocrdma_mqe *mqe,
> > 1118 void *payload_va)
> > 1119 {
> > 1120 int status;
> > 1121 struct ocrdma_mbx_rsp *rsp = payload_va;
> > 1122
> > 1123 if ((mqe->hdr.spcl_sge_cnt_emb & OCRDMA_MQE_HDR_EMB_MASK)
> > 1124 OCRDMA_MQE_HDR_EMB_SHIFT)
> > 1125 BUG();
> > 1126
> > 1127 status = ocrdma_mbx_cmd(dev, mqe);
> >
> > You are not using rsp and/or payload_va to provide data to ocrdma_mbx_cmd.
> >
> > How are you passing reset_stats information to FW?
> >
> This is a command where the response size is more than 236 bytes. So this is
> sent as a non-embedded command where the req/resp will be available in
> payload_va
> and phys address of payload_va (payload_pa) will be send down to
> firmware as MQE. FW will dma the mailbox
> from the payload_pa and response is transferred back.
>
> req->reset_stats = reset; is actually setting the corresponding bit in
> the request structure @payload_va.
> FW receives reset_stats once the request is DMA-ed from payload_pa.
Thanks
>
> > Thanks
> >
>
> Thanks,
> Selvin
Attachment:
signature.asc
Description: PGP signature
