Use netif_napi_add_config to assign persistent per-NAPI config when initializing RX CQ NAPIs. Presently, struct napi_config only has support for two fields used for RX, so there is no need to support them with TX CQs, yet. Signed-off-by: Joe Damato <jdamato@xxxxxxxxxx> --- drivers/net/ethernet/mellanox/mlx4/en_cq.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/drivers/net/ethernet/mellanox/mlx4/en_cq.c b/drivers/net/ethernet/mellanox/mlx4/en_cq.c index 461cc2c79c71..0e92956e84cf 100644 --- a/drivers/net/ethernet/mellanox/mlx4/en_cq.c +++ b/drivers/net/ethernet/mellanox/mlx4/en_cq.c @@ -156,7 +156,8 @@ int mlx4_en_activate_cq(struct mlx4_en_priv *priv, struct mlx4_en_cq *cq, break; case RX: cq->mcq.comp = mlx4_en_rx_irq; - netif_napi_add(cq->dev, &cq->napi, mlx4_en_poll_rx_cq); + netif_napi_add_config(cq->dev, &cq->napi, mlx4_en_poll_rx_cq, + cq_idx); netif_napi_set_irq(&cq->napi, irq); napi_enable(&cq->napi); netif_queue_set_napi(cq->dev, cq_idx, NETDEV_QUEUE_TYPE_RX, &cq->napi); -- 2.25.1
