On Fri, Aug 04, 2023 at 05:05:23PM +0200, Petr Pavlu wrote: > The mlx4_core driver has a logic that allows a sub-driver to set the > MLX4_INTFF_BONDING flag which then causes that function mlx4_do_bond() > asks the sub-driver to fully re-probe a device when its bonding > configuration changes. > > Performing this operation is disallowed in mlx4_register_interface() > when it is detected that any mlx4 device is multifunction (SRIOV). The > code then resets MLX4_INTFF_BONDING in the driver flags. > > Move this check directly into mlx4_do_bond(). It provides a better > separation as mlx4_core no longer directly modifies the sub-driver flags > and it will allow to get rid of explicitly keeping track of all mlx4 > devices by the intf.c code when it is switched to an auxiliary bus. > > Signed-off-by: Petr Pavlu <petr.pavlu@xxxxxxxx> > Tested-by: Leon Romanovsky <leon@xxxxxxxxxx> > --- > drivers/net/ethernet/mellanox/mlx4/intf.c | 19 +++++++++++-------- > 1 file changed, 11 insertions(+), 8 deletions(-) > Thanks, Reviewed-by: Leon Romanovsky <leonro@xxxxxxxxxx>
