On Thu, Sep 30, 2021 at 06:32:07PM +0300, Max Gurtovoy wrote: > > Just prior to open device the vfio pci layer will generate a FLR to > > the function so we expect that post open_device has a fresh from reset > > fully running device state. > > running also mean that the device doesn't have a clue on its internal state > ? or running means unfreezed and unquiesced ? The device just got FLR'd and it should be in a clean state and operating. Think the VM is booting for the first time. > > > > driver will see RESUMING toggle off so it will trigger a > > > > de-serialization > > > You mean stop serialization ? > > No, I mean it will take all the migration data that has been uploaded > > through the migration region and de-serialize it into active device > > state. > > you should feed the device way before that. I don't know what this means, when the resuming bit is set the migration data buffer is wiped and userspace should beging loading it. When the resuming bit is cleared whatever is in the migration buffer is deserialized into the current device internal state. It is the opposite of saving. When the saving bit is set the current device state is serialized into the migration buffer and userspace and reads it out. > 1. you initialize at _RUNNING bit == 001b. No problem. > > 2. state stream arrives, migration SW raise _RESUMING bit. should it be 101b > or 100b ? for now it's 100b. But according to your statement is should be > 101b (invalid today) since device state can change. right ? Running means the device state chanages independently, the controlled change of the device state via deserializing the migration buffer is different. Both running and saving commands need running to be zero. ie commands that are marked invalid in the uapi comment are rejected at the start - and that is probably the core helper we should provide. > 3. Then you should indicate that all the state was serialized to the device > (actually to all the pci devices). 100b mean RESUMING and not RUNNING so > maybe this can say RESUMED and state can't change now ? State is not loaded into the device until the resuming bit is cleared. There is no RESUMED state until we incorporate Artem's proposal for an additional bit eg 1001b - running with DMA master disabled. Jason
