From: Ariel Levkovich <lariel@xxxxxxxxxx> Set the flow source param to local vport for the uplink rep send-to-vport rule. This will comply with the recent changes in SW steering that use the flow source as an indication for the rule type - rx or tx. Since the uplink send-to-vport rule is forwarding traffic to the wire it has to indicate that it is an sx rule and can't use the any port value in the flow source. Signed-off-by: Ariel Levkovich <lariel@xxxxxxxxxx> Reviewed-by: Roi Dayan <roid@xxxxxxxxxx> Signed-off-by: Saeed Mahameed <saeedm@xxxxxxxxxx> --- drivers/net/ethernet/mellanox/mlx5/core/eswitch_offloads.c | 3 +++ 1 file changed, 3 insertions(+) diff --git a/drivers/net/ethernet/mellanox/mlx5/core/eswitch_offloads.c b/drivers/net/ethernet/mellanox/mlx5/core/eswitch_offloads.c index 12567002997f..1735be77e1fd 100644 --- a/drivers/net/ethernet/mellanox/mlx5/core/eswitch_offloads.c +++ b/drivers/net/ethernet/mellanox/mlx5/core/eswitch_offloads.c @@ -963,6 +963,9 @@ mlx5_eswitch_add_send_to_vport_rule(struct mlx5_eswitch *on_esw, dest.vport.flags |= MLX5_FLOW_DEST_VPORT_VHCA_ID; flow_act.action = MLX5_FLOW_CONTEXT_ACTION_FWD_DEST; + if (rep->vport == MLX5_VPORT_UPLINK) + spec->flow_context.flow_source = MLX5_FLOW_CONTEXT_FLOW_SOURCE_LOCAL_VPORT; + flow_rule = mlx5_add_flow_rules(on_esw->fdb_table.offloads.slow_fdb, spec, &flow_act, &dest, 1); if (IS_ERR(flow_rule)) -- 2.31.1
