From: Matthew Garrett <mjg@xxxxxxxxxx>
An HP laptop (Pavilion G4-1016tx) has the following code in _TMP:
Store (\_SB.PCI0.LPCB.EC0.RTMP, Local0)
If (LGreaterEqual (Local0, S4TP))
{
Store (One, HTS4)
}
S4TP is initialised at 0 and not programmed further until either _HOT or
_CRT is called. If we evaluate _TMP before the trip points then HTS4 will
always be set, causing the firmware to generate a message on boot
complaining that the system shut down because of overheating. The simplest
solution is just to reverse the checking of trip points and _TMP in thermal
init.
Signed-off-by: Matthew Garrett <mjg@xxxxxxxxxx>
Signed-off-by: Len Brown <len.brown@xxxxxxxxx>
---
drivers/acpi/thermal.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/acpi/thermal.c b/drivers/acpi/thermal.c
index 48fbc64..7dbebea 100644
--- a/drivers/acpi/thermal.c
+++ b/drivers/acpi/thermal.c
@@ -941,13 +941,13 @@ static int acpi_thermal_get_info(struct acpi_thermal *tz)
if (!tz)
return -EINVAL;
- /* Get temperature [_TMP] (required) */
- result = acpi_thermal_get_temperature(tz);
+ /* Get trip points [_CRT, _PSV, etc.] (required) */
+ result = acpi_thermal_get_trip_points(tz);
if (result)
return result;
- /* Get trip points [_CRT, _PSV, etc.] (required) */
- result = acpi_thermal_get_trip_points(tz);
+ /* Get temperature [_TMP] (required) */
+ result = acpi_thermal_get_temperature(tz);
if (result)
return result;
--
1.7.10.rc2.19.gfae9d
_______________________________________________
linux-pm mailing list
linux-pm@xxxxxxxxxxxxxxxxxxxxxxxxxx
https://lists.linuxfoundation.org/mailman/listinfo/linux-pm
