Hi Kevin, On Wed, Dec 14, 2011 at 12:53 AM, Kevin Hilman <khilman@xxxxxx> wrote: > Hi Jean, > > jean.pihet@xxxxxxxxxxxxxx writes: > >> From: Jean Pihet <j-pihet@xxxxxx> >> >> . Implement the devices wake-up latency constraints using the global >> device PM QoS notification handler which applies the constraints to the >> underlying layer >> . Implement the low level code which controls the power domains next power >> states, through the hwmod and pwrdm layers >> . Add cpuidle and power domains wake-up latency figures for OMAP3, cf. >> comments in the code and [1] for the details on where the numbers >> are magically coming from >> . Implement the relation between the cpuidle and per-device PM QoS frameworks >> in the OMAP3 specific idle callbacks. >> The chosen C-state shall satisfy the following conditions: >> . the 'valid' field is enabled, >> . it satisfies the enable_off_mode flag, >> . the next state for MPU and CORE power domains is not lower than the >> state programmed by the per-device PM QoS. > > I had a couple minor comments on this version, but after that, feel free > to add: > > Reviewed-by: Kevin Hilman <khilman@xxxxxx> Thanks for reviewing! I fixed (most of) the minor remarks and re-submitted. > after that, this series will go upstream through Paul. > > Kevin Regards, Jean _______________________________________________ linux-pm mailing list linux-pm@xxxxxxxxxxxxxxxxxxxxxxxxxx https://lists.linuxfoundation.org/mailman/listinfo/linux-pm
