From: Rafael J. Wysocki <rjw@xxxxxxx>
The runtime PM status of devices in a power domain that is not
powered off in pm_genpd_complete() should be set to "active", because
those devices are operational at this point. Some of them may not be
in use, though, so make pm_genpd_complete() call pm_runtime_idle()
in addition to pm_runtime_set_active() for each of them.
Signed-off-by: Rafael J. Wysocki <rjw@xxxxxxx>
---
drivers/base/power/domain.c | 2 ++
1 file changed, 2 insertions(+)
Index: linux-2.6/drivers/base/power/domain.c
===================================================================
--- linux-2.6.orig/drivers/base/power/domain.c
+++ linux-2.6/drivers/base/power/domain.c
@@ -786,7 +786,9 @@ static void pm_genpd_complete(struct dev
if (run_complete) {
pm_generic_complete(dev);
+ pm_runtime_set_active(dev);
pm_runtime_enable(dev);
+ pm_runtime_idle(dev);
}
}
_______________________________________________
linux-pm mailing list
linux-pm@xxxxxxxxxxxxxxxxxxxxxxxxxx
https://lists.linux-foundation.org/mailman/listinfo/linux-pm
