[PATCH 1/5 v1] PM / Domains: Set device state to "active" during system resume

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



From: Rafael J. Wysocki <rjw@xxxxxxx>

The runtime PM status of devices in a power domain that is not
powered off in pm_genpd_complete() should be set to "active", because
those devices are operational at this point.  Some of them may not be
in use, though, so make pm_genpd_complete() call pm_runtime_idle()
in addition to pm_runtime_set_active() for each of them.

Signed-off-by: Rafael J. Wysocki <rjw@xxxxxxx>
---
 drivers/base/power/domain.c |    2 ++
 1 file changed, 2 insertions(+)

Index: linux-2.6/drivers/base/power/domain.c
===================================================================
--- linux-2.6.orig/drivers/base/power/domain.c
+++ linux-2.6/drivers/base/power/domain.c
@@ -786,7 +786,9 @@ static void pm_genpd_complete(struct dev
 
 	if (run_complete) {
 		pm_generic_complete(dev);
+		pm_runtime_set_active(dev);
 		pm_runtime_enable(dev);
+		pm_runtime_idle(dev);
 	}
 }
 

_______________________________________________
linux-pm mailing list
linux-pm@xxxxxxxxxxxxxxxxxxxxxxxxxx
https://lists.linux-foundation.org/mailman/listinfo/linux-pm


[Index of Archives]     [Linux ACPI]     [Netdev]     [Ethernet Bridging]     [Linux Wireless]     [CPU Freq]     [Kernel Newbies]     [Fedora Kernel]     [Security]     [Linux for Hams]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux RAID]     [Linux Admin]     [Samba]

  Powered by Linux