I have a Logitech MX Revolution (a cordless mouse receiver) plugged into a Logitech G15 (a keyboard w/ a hub) plugged into an Intel Cougar Point EHCI controller. (Results are the same on an xHCI controller, though.) With autosuspend *or* runtime PM off, everything works. (Well, the G15 is buggy and occasionally crashes and doesn't recover until powercycled, but that even happens on Windows.) With runtime PM enabled on the whole tree, I have problems with autosuspend. If I enable autosuspend on just the mouse by doing: echo 2 >./1-1/1-1.2/1-1.2.3/power/autosuspend (where that device is Bus 001 Device 005: ID 046d:c51a Logitech, Inc. MX Revolution/G7 Cordless Mouse), then after about two seconds of not moving the mouse, the mouse ignores the first second or so of motion when I start moving it again. If I enable autosuspend on just part of the keyboard by doing: echo 2 >./1-1/1-1.2/1-1.2.1/power/autosuspend (that's Bus 001 Device 004: ID 046d:c221 Logitech, Inc. G11/G15 Keyboard / Keyboard) then after a couple seconds of not typing, my next keystroke is lost or delayed. It seems to be enough to turn off runtime PM (via power/control) OR turn off autosuspend on the keyboard device to make the keyboard work and on the mouse device to make the mouse work. Is this a case of "don't do that, you fool," or is there a legitimate bug to be fixed in the runtime pm code? My motherboard is Intel DH67GD (ordered just before they canceled production) with latest BIOS. _______________________________________________ linux-pm mailing list linux-pm@xxxxxxxxxxxxxxxxxxxxxxxxxx https://lists.linux-foundation.org/mailman/listinfo/linux-pm
