On Thu, Dec 30, 2010 at 04:49:29PM -0800, Maksim Rayskiy wrote: > >> When resuming from system suspend, scsi disks are being spun up which > >> takes quite a lot of time (5+ seconds in my case). The spinup is done > >> synchronously, so this time adds up to overall system resume time. > >> Ours is an embedded platform and we are using flash-based rootfs, so > >> there is no immediate need in harddrive after resume. What is much > >> more important for us is to minimize time-to-full-power. To speed up > >> resume, we would like to have an option to defer the spinup or run it > >> in parallel with system resume. I could not find any existing > >> mechanism to do the trick, but I might have missed something. > >> > >> Can anybody comment on this? > > > > Do you use asynchronous suspend/resume? > > > > Yes, asynchronous suspend/resume is enabled - it saves about 0.5 > second in my case. But resume blocks anyway because disk driver is > waiting on sd_resume() to complete. > > I am wondering if we could let the resume proceed while spinup is > going on, just mark the scsi device as quiescent to block any data > transfers. Yeah, it was asynchronous for a while when suspend/resume were implemented in libata proper. It's a bit trickier to do that with sd doing the higher level part. Hmmm... most SATA disks spin up automatically anyway so disabling START_STOP from sd should do the trick. Does the following achieve async resume? echo 0 > /sys/block/sdX/device/scsi_disk/h:c:i:l/manage_start_stop The problem is that the above would also prevent the kernel from issuing STANDBY_NOW on suspend or power down. Maybe we should just make start_stop_xlat schedule async EH action instead. Thanks. -- tejun _______________________________________________ linux-pm mailing list linux-pm@xxxxxxxxxxxxxxxxxxxxxxxxxx https://lists.linux-foundation.org/mailman/listinfo/linux-pm
