On Tuesday 27 April 2010 21:21:23 Alan Stern wrote:
> On Tue, 27 Apr 2010, Ondrej Zary wrote:
> > The previous patch was not enough as it worked only when there were no
> > USB devices connected. With a bus-powered device connected, power loss
> > causes disconnect which wakes up the machine immediately again.
>
> You said earlier that the host controller was disabled for remote
> wakeup ("/sys/devices/pci0000:00/0000:00:1d.7/power/wakeup is disabled
> by default"). So even though the root hub might issue a wakeup
> request, the controller hardware should not forward that request to the
> PCI bus and it should not cause the system to wake up.
Maybe it should not - but it wakes up this board and probably also P4P800,
P4P800-E and P4C800-E at least:
https://bugs.launchpad.net/ubuntu/+source/linux/+bug/75497
> > Does anyone know why is this enabled by default?
>
> Why _what_ is enabled? Detection of disconnects? Because otherwise
> your computer wouldn't realize anything had happened when a suspended
> USB device was unplugged from a suspended root hub.
That's not disconnect detection - that's wakeup on disconnect. If I understand
EHCI 1.0 specification correctly, disconnect detection should work regardless
of the state of this bit:
| PORTSC bit 21: Wake on Disconnect Enable (WKDSCNNT_E):
| R/W. Default = 0b.
| Writing this bit to a one enables the port to be sensitive to device
| disconnects as wake-up events. See Section 4.3 for effects of this bit on
| resume event behavior. Refer to Section 4.3.1 for operational model.
And it really does. With this patch applied, system does not wake up when a
device is disconnected during suspend. When I wake up the system manually,
the disconnect is detected immediately (does not matter
> > No other USB host driver
> > (except oxu210hp-hcd which is based on EHCI) does that.
>
> Look again -- they all do. (All the HCDs that support suspend/resume,
> anyway.)
>
> > This also means that
> > suspended laptop wakes up when disconnecting a mouse?
>
> No, for the reason I described above. The controller is aware of the
> wakeup request but doesn't generate a PME# event. Likewise for desktop
> systems.
>
> > I don't have any to test
> > right now. Wakeup on USB connect makes a bit more sense but I'd say that
> > it's still not a good idea to enable it by default.
> >
> > If we don't need that, perhaps the following patch should be applied.
> >
> >
> > Disable wake on overcurrent and disconnect in EHCI.
> > This fixes immediate resume from standby on boards where port power is
> > lost in standby which triggers overcurrent detection and disconnect if a
> > bus-powered device is connected. At least Asus P4P800 boards are affected
> > when any of the USBPWxx (e.g. USBPW12) jumpers is set to 5V.
>
> Why would you want to change the jumper settings? Host controllers are
> _supposed_ to supply 5V power during system suspend.
Maybe because I don't want all my USB devices to be powered when the system is
turned off. I doubt that laptop in suspend-to-RAM (on battery) provides power
to USB ports.
--
Ondrej Zary
_______________________________________________
linux-pm mailing list
linux-pm@xxxxxxxxxxxxxxxxxxxxxxxxxx
https://lists.linux-foundation.org/mailman/listinfo/linux-pm
