On Sat, Feb 27, 2010 at 02:28:44PM +0100, Ákos Maróy wrote: > Rafael, > > > Does it also happen if you rmmod the xhci-hcd module manually and run > > "echo disk > /sys/power/state" afterwards? > > yes. I do an rmmod xhci, lsmod | grep xhci returns nothing, and then > echo disk > /sys/power/state will give me the same result as > pm-hibernate. that is, I get to an empty screen, there's a cursor > blinking on the top left. after a while, the screen dims, but nothing > else happens. only a power cycle saves the day, where the machine boots > normally, when just turned on. > > how could I debug these happenings further? Did you try it without framebuffer and X.org? It seems to me that the system wakes up correctly, but the graphics card is this issue. I had this with my old laptop too. Regards, Matthias-Christian _______________________________________________ linux-pm mailing list linux-pm@xxxxxxxxxxxxxxxxxxxxxxxxxx https://lists.linux-foundation.org/mailman/listinfo/linux-pm
