On Fri, August 8, 2008 08:14, Pavel Machek wrote: > On Mon 2008-08-04 22:56:07, Simon Arlott wrote: >> My system (Tyan S2923-E, dmesg attached) suspends ok in >> all pm_test modes, but it won't resume with pm_test >> "none". >> >> [ 6.423515] mem full: hash matches >> >> When I press the power button, the port 80 display shows: >> FF D0 23 01 D0 ... DE >> (and again each time I press it) >> >> If I force it to turn off, then on again: >> FF D0 23 01 D0 ... FF D0 23 01 D0 ... (D2?) D3 00 01 D5 >> D6 <normal boot> >> >> Any ideas? (onboard SAS is disabled, watchdog is >> disabled, everything else is enabled, PCI-E graphics >> card) > > Try verifying if it reaches assembly code under realmode/ ... I was looking at the acpi code last night but I couldn't figure out where the last code before the actual suspend is or where it starts executing again. I'm also not sure how to do it, could you provide a quick patch that immediately writes something to port 80 before doing anything else? -- Simon Arlott _______________________________________________ linux-pm mailing list linux-pm@xxxxxxxxxxxxxxxxxxxxxxxxxx https://lists.linux-foundation.org/mailman/listinfo/linux-pm
