From: Alan Stern <stern@xxxxxxxxxxxxxxxxxxx>
This patch (as1059) fixes a mistake in the way the serial core
initializes a device's wakeup settings. It should use the accessor
routine instead of relying on a macro producing an lvalue.
Signed-off-by: Alan Stern <stern@xxxxxxxxxxxxxxxxxxx>
Signed-off-by: Rafael J. Wysocki <rjw@xxxxxxx>
---
Index: usb-2.6/drivers/serial/serial_core.c
===================================================================
--- usb-2.6.orig/drivers/serial/serial_core.c
+++ usb-2.6/drivers/serial/serial_core.c
@@ -2356,7 +2356,7 @@ int uart_add_one_port(struct uart_driver
*/
tty_dev = tty_register_device(drv->tty_driver, port->line, port->dev);
if (likely(!IS_ERR(tty_dev))) {
- device_can_wakeup(tty_dev) = 1;
+ device_init_wakeup(tty_dev, 1);
device_set_wakeup_enable(tty_dev, 0);
} else
printk(KERN_ERR "Cannot register tty device on line %d\n",
_______________________________________________
linux-pm mailing list
linux-pm@xxxxxxxxxxxxxxxxxxxxxxxxxx
https://lists.linux-foundation.org/mailman/listinfo/linux-pm
