On Wed, Jun 20, 2007 at 12:33:04PM -0400, Alan Stern wrote: > On Wed, 20 Jun 2007, Mattia Dongili wrote: > > > > Just as with Raphael, I suggest you build a kernel with > > > CONFIG_USB_DEBUG turned on and then post the dmesg log showing the USB > > > debugging messages during the suspend and immediate resume. To reduce > > > the amount of clutter you might want to rmmod uhci-hcd before starting > > > the test. > > > > here we go: > > http://www.linux.it/~malattia/logs/dmesg-suspend-ehci-debug-log > > > > and by the way: > > 00:1d.0 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI #1 (rev 02) > > 00:1d.1 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI #2 (rev 02) > > 00:1d.2 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI #3 (rev 02) > > 00:1d.3 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI #4 (rev 02) > > 00:1d.7 USB Controller: Intel Corporation 82801G (ICH7 Family) USB2 EHCI Controller (rev 02) > > > > with ehci only: > > Bus 005 Device 007: ID 054c:0281 Sony Corp. > > Bus 005 Device 004: ID 05ca:1830 Ricoh Co., Ltd > > Bus 005 Device 001: ID 0000:0000 > > The log shows suspicious behavior on the part of the Sony UMH-U09 > device, the first one in your ehci-only list above. When it was > suspended it apparently disconnected itself from the USB bus, thereby > triggering a wakeup signal. If at all possible, try unplugging the USB > cable to that device and then see what happens when you suspend. wow, spotted! This device is an express card (SD/MMC reader). Do you have any suggestion to make suspend work without any workarounds? I mean, all of this started by enabling wakeup on the ehci controller USB1 S3 disabled pci:0000:00:1d.0 USB2 S3 disabled pci:0000:00:1d.1 USB3 S3 disabled pci:0000:00:1d.2 USB4 S3 disabled pci:0000:00:1d.3 USB7 S3 enabled pci:0000:00:1d.7 and this was triggered when trying to understand if enabling wakeup by default on PCI devices was good or not (and the patch itself was responsible or not for problems). So, from my POV it's either not good or there has to be some way of dealing with disconnecting devices on suspend. Just to simplify, in this situation, if I had an usb mouse attached to this usb controller and removed the mouse while suspended, would the laptop wakeup? If so that's not what I most probably want. :) > You also ought to be able to prevent this immediate resume by disabling > wakeup on the EHCI controller. For example: > > echo disable >/sys/bus/usb/devices/usb5/power/wakeup > echo disable >/sys/bus/usb/devices/usb5/../power/wakeup that doesn't seem to work very well (on -rc5 at least): $ echo disable > /sys/bus/usb/devices/usb2/power/wakeup echo: write error: invalid argument The only value that seems to be accepted is 0 but reading the value gives always "enabled". Thanks -- mattia :wq! _______________________________________________ linux-pm mailing list linux-pm@xxxxxxxxxxxxxxxxxxxxxxxxxx https://lists.linux-foundation.org/mailman/listinfo/linux-pm
