Hi all,
I have been investigating the random invalid instruction occourances on
sparc32 (sun4c) and identified that the problem was introduced
pre-v2.6.22-rc1. v2.6.21 is OK. The first time I have observed the issue
so far is after commit b46b8f19c9cd435ecac4d9d12b39d78c137ecd66:
Increase slab redzone to 64bits.
Prior to this commit there apears to be a problem with the memory
management (depmod -a causes the system to run out of memory!) that may be
masking the issue. As a result of this, I am going to try to find the
'last known good' commit after v2.6.21 to see if this helps narrow down
the cause.
Regards
Mark Fortescue.
On Thu, 14 Jun 2007, William Lee Irwin III wrote:
On Thu, Jun 14, 2007 at 11:30:25AM +0100, Mark Fortescue wrote:
They apear as soon as simpleinit starts up. Somtimes I get to a login
prompt before seeing any. Other times, commands in the simpleinit rc
script fail.
They do apear to be random. If a command failes, you re-run the command
and it is OK. Commands seen to fail are basic (depmod, rm cat ..).
The test I did use the same binaries with both the OK and problem kernels
so it is not a change to the application code, it is definatly a kernel
issue.
This sounds like it may be addressed by benh's ptep_set_access_flags()
fixes. Those fixes are still in -mm, hopefully to hit mainline by 2.6.22.
-- wli
_______________________________________________
linux-pm mailing list
linux-pm@xxxxxxxxxxxxxxxxxxxxxxxxxx
https://lists.linux-foundation.org/mailman/listinfo/linux-pm
