From: Hongtao Wu <billows.wu@xxxxxxxxxx> This series adds PCIe bindings for Unisoc SoCs. This controller is based on DesignWare PCIe IP. Signed-off-by: Hongtao Wu <billows.wu@xxxxxxxxxx> --- .../devicetree/bindings/pci/sprd-pcie.yaml | 101 +++++++++++++++++++++ 1 file changed, 101 insertions(+) create mode 100644 Documentation/devicetree/bindings/pci/sprd-pcie.yaml diff --git a/Documentation/devicetree/bindings/pci/sprd-pcie.yaml b/Documentation/devicetree/bindings/pci/sprd-pcie.yaml new file mode 100644 index 0000000..c52edfb --- /dev/null +++ b/Documentation/devicetree/bindings/pci/sprd-pcie.yaml @@ -0,0 +1,101 @@ +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/pci/sprd-pcie.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: SoC PCIe Host Controller Device Tree Bindings + +maintainers: + - Hongtao Wu <billows.wu@xxxxxxxxxx> + +allOf: + - $ref: /schemas/pci/pci-bus.yaml# + +properties: + compatible: + items: + - const: sprd,pcie-rc + + reg: + minItems: 2 + items: + - description: Controller control and status registers. + - description: PCIe configuration registers. + + reg-names: + items: + - const: dbi + - const: config + + ranges: + maxItems: 2 + + num-lanes: + maximum: 1 + description: Number of lanes to use for this port. + + interrupts: + minItems: 1 + description: Builtin MSI controller and PCIe host controller. + + interrupt-names: + items: + - const: msi + + sprd-pcie-poweron-syscons: + minItems: 1 + description: Global register. + The first value is the phandle to the global registers required to + confige PCIe phy, clock and so on. + The second value is the global register type which indicates whether it + is a set/clear register or not. + The third value is the time to delay after the global register is set or + cleared. + The fourth value is the global register address. + The fifth value is the the mask value that the global register must + be operate. + The sixth value is the value that will be set to the global register. + Note that Some Unisoc global registers have not been upstreamed. + The global register and its mask can't be found in linux kernel, + so we use an offset address and a number to instead them. + +required: + - compatible + - reg + - reg-names + - num-lanes + - ranges + - interrupts + - interrupt-names + +examples: + - | + #include <dt-bindings/interrupt-controller/arm-gic.h> + + ipa { + #address-cells = <2>; + #size-cells = <2>; + + pcie0: pcie@2b100000 { + compatible = "sprd,pcie-rc"; + reg = <0x0 0x2b100000 0x0 0x2000>, + <0x2 0x00000000 0x0 0x2000>; + reg-names = "dbi", "config"; + #address-cells = <3>; + #size-cells = <2>; + device_type = "pci"; + ranges = <0x01000000 0x0 0x00000000 0x2 0x00002000 0x0 0x00010000>, + <0x03000000 0x0 0x10000000 0x2 0x10000000 0x1 0xefffffff>; + num-lanes = <1>; + interrupts = <GIC_SPI 153 IRQ_TYPE_LEVEL_HIGH>; + interrupt-names = "msi"; + + sprd,pcie-poweron-syscons = + <&ap_ipa_ahb_regs 0 0 0x0000 0x40 0x40>, + <&ap_ipa_ahb_regs 0 0 0x0000 0x20 0x20>; + sprd,pcie-poweroff-syscons = + <&ap_ipa_ahb_regs 0 0 0x0000 0x20 0x0>, + <&ap_ipa_ahb_regs 0 0 0x0000 0x40 0x0>; + }; + }; -- 2.7.4
