The following was observed by Kar Hin Ong with RT patchset:
Backtrace:
irq 19: nobody cared (try booting with the "irqpoll" option)
CPU: 0 PID: 3329 Comm: irq/34-nipalk Tainted:4.14.87-rt49 #1
Hardware name: National Instruments NI PXIe-8880/NI PXIe-8880,
BIOS 2.1.5f1 01/09/2020
Call Trace:
<IRQ>
? dump_stack+0x46/0x5e
? __report_bad_irq+0x2e/0xb0
? note_interrupt+0x242/0x290
? nNIKAL100_memoryRead16+0x8/0x10 [nikal]
? handle_irq_event_percpu+0x55/0x70
? handle_irq_event+0x4f/0x80
? handle_fasteoi_irq+0x81/0x180
? handle_irq+0x1c/0x30
? do_IRQ+0x41/0xd0
? common_interrupt+0x84/0x84
</IRQ>
...
handlers:
[<ffffffffb3297200>] irq_default_primary_handler threaded
[<ffffffffb3669180>] usb_hcd_irq
Disabling IRQ #19
The problem being that this device is triggering boot interrupts
due to threaded interrupt handling and masking of the IO-APIC. These
boot interrupts are then forwarded on to the legacy PCH's PIRQ lines
where there is no handler present for the device.
Whenever a PCI device is firing interrupt (INTx) to Pin 20 of IOAPIC 2
(GSI 44); the kernel will receives 2 interrupts:
1. Interrupt from Pin 20 of IOAPIC 2 -> Expected
2. Interrupt from Pin 19 of IOAPIC 1 -> UNEXPECTED
Quirks for disabling boot interrupts (preferred) or rerouting the handler
exist but do not address these Xeon chipsets' mechanism:
https://lore.kernel.org/lkml/12131949181903-git-send-email-sassmann@xxxxxxx/
This patch adds a new mechanism via PCI CFG for those chipsets supporting
CIPINTRC register's dis_intx_rout2ich bit.
Reported-by: Kar Hin Ong <kar.hin.ong@xxxxxx>
Tested-by: Kar Hin Ong <kar.hin.ong@xxxxxx>
Signed-off-by: Sean V Kelley <sean.v.kelley@xxxxxxxxxxxxxxx>
---
drivers/pci/quirks.c | 80 ++++++++++++++++++++++++++++++++++++++++----
1 file changed, 73 insertions(+), 7 deletions(-)
diff --git a/drivers/pci/quirks.c b/drivers/pci/quirks.c
index 29f473ebf20f..e8ee670877d1 100644
--- a/drivers/pci/quirks.c
+++ b/drivers/pci/quirks.c
@@ -1970,26 +1970,92 @@ DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_80332_1, quirk
/*
* IO-APIC1 on 6300ESB generates boot interrupts, see Intel order no
* 300641-004US, section 5.7.3.
+ *
+ * Core IO on Xeon E5 1600/2600/4600, see Intel order no 326509-003.
+ * Core IO on Xeon E5 v2, see Intel order no 329188-003.
+ * Core IO on Xeon E7 v2, see Intel order no 329595-002.
+ * Core IO on Xeon E5 v3, see Intel order no 330784-003.
+ * Core IO on Xeon E7 v3, see Intel order no 332315-001US.
+ * Core IO on Xeon E5 v4, see Intel order no 333810-002US.
+ * Core IO on Xeon E7 v4, see Intel order no 332315-001US.
+ * Core IO on Xeon D-1500, see Intel order no 332051-001.
+ * Core IO on Xeon Scalable, see Intel order no 610950.
*/
-#define INTEL_6300_IOAPIC_ABAR 0x40
+#define INTEL_6300_IOAPIC_ABAR 0x40 /* Bus 0, Dev 29, Func 5 */
#define INTEL_6300_DISABLE_BOOT_IRQ (1<<14)
+#define INTEL_CIPINTRC_CFG_OFFSET 0x14C /* Bus 0, Dev 5, Func 0 */
+#define INTEL_CIPINTRC_DIS_INTX_ICH (1<<25)
+
static void quirk_disable_intel_boot_interrupt(struct pci_dev *dev)
{
u16 pci_config_word;
+ u32 pci_config_dword;
if (noioapicquirk)
return;
- pci_read_config_word(dev, INTEL_6300_IOAPIC_ABAR, &pci_config_word);
- pci_config_word |= INTEL_6300_DISABLE_BOOT_IRQ;
- pci_write_config_word(dev, INTEL_6300_IOAPIC_ABAR, pci_config_word);
-
+ switch (dev->device) {
+ case PCI_DEVICE_ID_INTEL_ESB_10:
+ pci_read_config_word(dev, INTEL_6300_IOAPIC_ABAR,
+ &pci_config_word);
+ pci_config_word |= INTEL_6300_DISABLE_BOOT_IRQ;
+ pci_write_config_word(dev, INTEL_6300_IOAPIC_ABAR,
+ pci_config_word);
+ break;
+ case 0x3c28: /* Xeon E5 1600/2600/4600 */
+ case 0x0e28: /* Xeon E5/E7 V2 */
+ case 0x2f28: /* Xeon E5/E7 V3,V4 */
+ case 0x6f28: /* Xeon D-1500 */
+ case 0x2034: /* Xeon Scalable Family */
+ pci_read_config_dword(dev, INTEL_CIPINTRC_CFG_OFFSET,
+ &pci_config_dword);
+ pci_config_dword |= INTEL_CIPINTRC_DIS_INTX_ICH;
+ pci_write_config_dword(dev, INTEL_CIPINTRC_CFG_OFFSET,
+ pci_config_dword);
+ break;
+ default:
+ return;
+ }
pci_info(dev, "disabled boot interrupts on device [%04x:%04x]\n",
dev->vendor, dev->device);
}
-DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_ESB_10, quirk_disable_intel_boot_interrupt);
-DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_ESB_10, quirk_disable_intel_boot_interrupt);
+/*
+ * Device 29 Func 5 Device IDs of IOxAPIC
+ * containing ABAR—APIC1 Alternate Base Address Register
+ */
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_ESB_10,
+ quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_ESB_10,
+ quirk_disable_intel_boot_interrupt);
+
+/*
+ * Device 5 Func 0 Device IDs of IIO or Core modules/hubs
+ * containing Coherent Interface Protocol Interrupt Control
+ *
+ * Device IDs obtained from volume 2 datasheets of commented
+ * families above.
+ */
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_INTEL, 0x3c28,
+ quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_INTEL, 0x0e28,
+ quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_INTEL, 0x2f28,
+ quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_INTEL, 0x6f28,
+ quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_INTEL, 0x2034,
+ quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL, 0x3c28,
+ quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL, 0x0e28,
+ quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL, 0x2f28,
+ quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL, 0x6f28,
+ quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL, 0x2034,
+ quirk_disable_intel_boot_interrupt);
/* Disable boot interrupts on HT-1000 */
#define BC_HT1000_FEATURE_REG 0x64
--
2.25.0
