Re: [PATCH] dma-mapping: treat dev->bus_dma_mask as a DMA limit

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 13/11/2019 4:13 pm, Nicolas Saenz Julienne wrote:
Using a mask to represent bus DMA constraints has a set of limitations.
The biggest one being it can only hold a power of two (minus one). The
DMA mapping code is already aware of this and treats dev->bus_dma_mask
as a limit. This quirk is already used by some architectures although
still rare.

With the introduction of the Raspberry Pi 4 we've found a new contender
for the use of bus DMA limits, as its PCIe bus can only address the
lower 3GB of memory (of a total of 4GB). This is impossible to represent
with a mask. To make things worse the device-tree code rounds non power
of two bus DMA limits to the next power of two, which is unacceptable in
this case.

In the light of this, rename dev->bus_dma_mask to dev->bus_dma_limit all
over the tree and treat it as such. Note that dev->bus_dma_limit is
meant to contain the higher accesible DMA address.

Neat, you win a "why didn't I do it that way in the first place?" :)

Looking at it without all the history of previous attempts, this looks entirely reasonable, and definitely a step in the right direction.

[...]
diff --git a/drivers/acpi/arm64/iort.c b/drivers/acpi/arm64/iort.c
index 5a7551d060f2..f18827cf96df 100644
--- a/drivers/acpi/arm64/iort.c
+++ b/drivers/acpi/arm64/iort.c
@@ -1097,7 +1097,7 @@ void iort_dma_setup(struct device *dev, u64 *dma_addr, u64 *dma_size)
  		 * Limit coherent and dma mask based on size
  		 * retrieved from firmware.
  		 */
-		dev->bus_dma_mask = mask;
+		dev->bus_dma_limit = mask;

Although this preserves the existing behaviour, as in of_dma_configure() we can do better here since we have the original address range to hand. I think it's worth keeping the ACPI and OF paths in sync for minor tweaks like this, rather than letting them diverge unnecessarily.

Otherwise, the rest looks OK to me - in principle we could store it as an exclusive limit such that we could then streamline the min_not_zero() tests to just min(mask, limit - 1), but that's probably too clever for its own good.

Robin.

  		dev->coherent_dma_mask = mask;
  		*dev->dma_mask = mask;
  	}



[Index of Archives]     [DMA Engine]     [Linux Coverity]     [Linux USB]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Greybus]

  Powered by Linux