From: Bjorn Helgaas > Sent: 27 September 2019 23:02 > On Fri, Aug 16, 2019 at 07:50:41PM +0300, Sergey Miroshnichenko wrote: > > When hot-adding a device, the bridge may have windows not big enough (or > > fragmented too much) for newly requested BARs to fit in. And expanding > > these bridge windows may be impossible because blocked by "neighboring" > > BARs and bridge windows. > > > > Still, it may be possible to allocate a memory region for new BARs with the > > following procedure: > > > > 1) notify all the drivers which support movable BARs to pause and release > > the BARs; the rest of the drivers are guaranteed that their devices will > > not get BARs moved; > > > > 2) release all the bridge windows except of root bridges; > > > > 3) try to recalculate new bridge windows that will fit all the BAR types: > > - fixed; > > - immovable; > > - movable; > > - newly requested by hot-added devices; > > > > 4) if the previous step fails, disable BARs for one of the hot-added > > devices and retry from step 3; > > > > 5) notify the drivers, so they remap BARs and resume. > > You don't do the actual recalculation in *this* patch, but since you > mention the procedure here, are we confident that we never make things > worse? > > It's possible that a hot-add will trigger this attempt to move things > around, and it's possible that we won't find space for the new device > even if we move things around. But are we certain that every device > that worked *before* the hot-add will still work *afterwards*? > > Much of the assignment was probably done by the BIOS using different > algorithms than Linux has, so I think there's some chance that the > BIOS did a better job and if we lose that BIOS assignment, we might > not be able to recreate it. Yep, removing everything and starting again is probably OTT and most of the churn won't help. I think you need to work out what can be moved in order to make the required resources available to each bus and then make the required changes. In the simplest case you are trying to add resource below a bridge so need to 'shuffle' everything allocated after that bridge to later addresses (etc). Many devices that support address reassignment might not need to be moved - so there is no point remmapping them. There is also the case when a device that is present but not currently is use could be taken through a remove+insert sequence in order to change its resources. Much easier to implement than 'remap while active'. This would require a call into the driver (than can sleep) to request whether it is idle. (and probably one at the end if the remove wasn't done). David - Registered Address Lakeside, Bramley Road, Mount Farm, Milton Keynes, MK1 1PT, UK Registration No: 1397386 (Wales)
