On Mon, Sep 16, 2019 at 02:50:21PM +0200, Neil Armstrong wrote:
> This adds the Amlogic G12A PCI Express controller node, also
> using the USB3+PCIe Combo PHY.
>
> The PHY mode selection is static, thus the USB3+PCIe Combo PHY
> phandle would need to be removed from the USB control node if the
> shared differential lines are used for PCIe instead of USB3.
>
> Signed-off-by: Neil Armstrong <narmstrong@xxxxxxxxxxxx>
Reviewed-by: Andrew Murray <andrew.murray@xxxxxxx>
> ---
> .../boot/dts/amlogic/meson-g12-common.dtsi | 33 +++++++++++++++++++
> arch/arm64/boot/dts/amlogic/meson-sm1.dtsi | 4 +++
> 2 files changed, 37 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/amlogic/meson-g12-common.dtsi b/arch/arm64/boot/dts/amlogic/meson-g12-common.dtsi
> index 852cf9cf121b..7330dc37b7a6 100644
> --- a/arch/arm64/boot/dts/amlogic/meson-g12-common.dtsi
> +++ b/arch/arm64/boot/dts/amlogic/meson-g12-common.dtsi
> @@ -95,6 +95,39 @@
> #size-cells = <2>;
> ranges;
>
> + pcie: pcie@fc000000 {
> + compatible = "amlogic,g12a-pcie", "snps,dw-pcie";
> + reg = <0x0 0xfc000000 0x0 0x400000
> + 0x0 0xff648000 0x0 0x2000
> + 0x0 0xfc400000 0x0 0x200000>;
> + reg-names = "elbi", "cfg", "config";
> + interrupts = <GIC_SPI 221 IRQ_TYPE_LEVEL_HIGH>;
> + #interrupt-cells = <1>;
> + interrupt-map-mask = <0 0 0 0>;
> + interrupt-map = <0 0 0 0 &gic GIC_SPI 223 IRQ_TYPE_LEVEL_HIGH>;
> + bus-range = <0x0 0xff>;
> + #address-cells = <3>;
> + #size-cells = <2>;
> + device_type = "pci";
> + ranges = <0x81000000 0 0 0x0 0xfc600000 0 0x00100000
> + 0x82000000 0 0xfc700000 0x0 0xfc700000 0 0x1900000>;
> +
> + clocks = <&clkc CLKID_PCIE_PHY
> + &clkc CLKID_PCIE_COMB
> + &clkc CLKID_PCIE_PLL>;
> + clock-names = "general",
> + "pclk",
> + "port";
> + resets = <&reset RESET_PCIE_CTRL_A>,
> + <&reset RESET_PCIE_APB>;
> + reset-names = "port",
> + "apb";
> + num-lanes = <1>;
> + phys = <&usb3_pcie_phy PHY_TYPE_PCIE>;
> + phy-names = "pcie";
> + status = "disabled";
> + };
> +
> ethmac: ethernet@ff3f0000 {
> compatible = "amlogic,meson-axg-dwmac",
> "snps,dwmac-3.70a",
> diff --git a/arch/arm64/boot/dts/amlogic/meson-sm1.dtsi b/arch/arm64/boot/dts/amlogic/meson-sm1.dtsi
> index 91492819d0d8..ee9ea3c69433 100644
> --- a/arch/arm64/boot/dts/amlogic/meson-sm1.dtsi
> +++ b/arch/arm64/boot/dts/amlogic/meson-sm1.dtsi
> @@ -135,6 +135,10 @@
> power-domains = <&pwrc PWRC_SM1_ETH_ID>;
> };
>
> +&pcie {
> + power-domains = <&pwrc PWRC_SM1_PCIE_ID>;
> +};
> +
> &pwrc {
> compatible = "amlogic,meson-sm1-pwrc";
> };
> --
> 2.22.0
>
