> -----Original Message-----
> From: Gustavo Pimentel <Gustavo.Pimentel@xxxxxxxxxxxx>
> Sent: Thursday, September 12, 2019 7:52 PM
> To: Pankaj Dubey <pankaj.dubey@xxxxxxxxxxx>; linux-pci@xxxxxxxxxxxxxxx;
> linux-kernel@xxxxxxxxxxxxxxx
> Cc: jingoohan1@xxxxxxxxx; Gustavo.Pimentel@xxxxxxxxxxxx;
> lorenzo.pieralisi@xxxxxxx; bhelgaas@xxxxxxxxxx; Anvesh Salveru
> <anvesh.s@xxxxxxxxxxx>
> Subject: RE: [PATCH 1/2] PCI: dwc: Add support to disable GEN3 equalization
>
> Hi,
>
> On Tue, Sep 10, 2019 at 13:25:1, Pankaj Dubey <pankaj.dubey@xxxxxxxxxxx>
> wrote:
>
> > From: Anvesh Salveru <anvesh.s@xxxxxxxxxxx>
> >
> > In some platforms, PCIe PHY may have issues which will prevent linkup
> > to happen in GEN3 or high speed. In case equalization fails, link will
> > fallback to GEN1.
> >
> > Designware controller has support for disabling GEN3 equalization if
> > required. This patch enables the designware driver to disable the PCIe
> > GEN3 equalization by writing into PCIE_PORT_GEN3_RELATED.
>
> s/Designware/DesignWare
> s/designware/DesignWare
>
> >
> > Platform drivers can disable equalization by setting the dwc_pci_quirk
> > flag DWC_EQUALIZATION_DISABLE.
> >
> > Signed-off-by: Anvesh Salveru <anvesh.s@xxxxxxxxxxx>
> > Signed-off-by: Pankaj Dubey <pankaj.dubey@xxxxxxxxxxx>
> > ---
> > drivers/pci/controller/dwc/pcie-designware.c | 7 +++++++
> > drivers/pci/controller/dwc/pcie-designware.h | 7 +++++++
> > 2 files changed, 14 insertions(+)
> >
> > diff --git a/drivers/pci/controller/dwc/pcie-designware.c
> > b/drivers/pci/controller/dwc/pcie-designware.c
> > index 7d25102..bf82091 100644
> > --- a/drivers/pci/controller/dwc/pcie-designware.c
> > +++ b/drivers/pci/controller/dwc/pcie-designware.c
> > @@ -466,4 +466,11 @@ void dw_pcie_setup(struct dw_pcie *pci)
> > break;
> > }
> > dw_pcie_writel_dbi(pci, PCIE_LINK_WIDTH_SPEED_CONTROL, val);
> > +
> > + val = dw_pcie_readl_dbi(pci, PCIE_PORT_GEN3_RELATED);
> > +
> > + if (pci->dwc_pci_quirk & DWC_EQUALIZATION_DISABLE)
> > + val |= PORT_LOGIC_GEN3_EQ_DISABLE;
> > +
> > + dw_pcie_writel_dbi(pci, PCIE_PORT_GEN3_RELATED, val);
> > }
> > diff --git a/drivers/pci/controller/dwc/pcie-designware.h
> > b/drivers/pci/controller/dwc/pcie-designware.h
> > index ffed084..a1453c5 100644
> > --- a/drivers/pci/controller/dwc/pcie-designware.h
> > +++ b/drivers/pci/controller/dwc/pcie-designware.h
> > @@ -29,6 +29,9 @@
> > #define LINK_WAIT_MAX_IATU_RETRIES 5
> > #define LINK_WAIT_IATU 9
> >
> > +/* Parameters for PCIe Quirks */
> > +#define DWC_EQUALIZATION_DISABLE 0x1
> > +
> > /* Synopsys-specific PCIe configuration registers */
> > #define PCIE_PORT_LINK_CONTROL 0x710
> > #define PORT_LINK_MODE_MASK GENMASK(21, 16)
> > @@ -60,6 +63,9 @@
> > #define PCIE_MSI_INTR0_MASK 0x82C
> > #define PCIE_MSI_INTR0_STATUS 0x830
> >
> > +#define PCIE_PORT_GEN3_RELATED 0x890
> > +#define PORT_LOGIC_GEN3_EQ_DISABLE BIT(16)
> > +
> > #define PCIE_ATU_VIEWPORT 0x900
> > #define PCIE_ATU_REGION_INBOUND BIT(31)
> > #define PCIE_ATU_REGION_OUTBOUND 0
> > @@ -244,6 +250,7 @@ struct dw_pcie {
> > struct dw_pcie_ep ep;
> > const struct dw_pcie_ops *ops;
> > unsigned int version;
> > + unsigned int dwc_pci_quirk;
>
> I'd prefer called this variable just quirk, the prefix is redundant here.
>
> > };
> >
> > #define to_dw_pcie_from_pp(port) container_of((port), struct dw_pcie,
> > pp)
> > --
> > 2.7.4
>
> I understand your idea and I'm fine with it, but I just wonder if there isn't any
> other typical way to do this kind of quirks... I'm not seeing a similar case to this
> although.
Even we didn't see any existing approach to address this.
> For me makes more sense to squash both patches (1 and 2), since we aim to add
> this quirk especially because it focuses is on this "GEN3_RELATED"
> register in a logical patch.
>
Done. Posted [v2] where we squashed both the patches.
v2: https://lkml.org/lkml/2019/9/13/171
Thanks for review.
> Regards,
> Gustavo
