Some host controllers need to know the existence of clkreq signal routing
to downstream devices to be able to advertise low power features like
ASPM L1 substates. Without clkreq signal routing being present, enabling
ASPM L1 substates might lead to downstream devices being disconnected
from the bus. Hence a new device tree property 'supports-clkreq' is added
to make such host controllers aware of clkreq signal routing to
downstream devices.
Signed-off-by: Vidya Sagar <vidyas@xxxxxxxxxx>
Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
Reviewed-by: Thierry Reding <treding@xxxxxxxxxx>
---
V15:
* None
V14:
* s/falling off the bus/being disconnected from the bus/ in commit message.
V13:
* None
V12:
* Rebased on top of linux-next top of the tree
V11:
* None
V10:
* None
V9:
* None
V8:
* None
V7:
* None
V6:
* s/Documentation\/devicetree/dt-bindings/ in the subject
V5:
* None
V4:
* Rebased on top of linux-next top of the tree
V3:
* None
V2:
* This is a new patch in v2 series
Documentation/devicetree/bindings/pci/pci.txt | 5 +++++
1 file changed, 5 insertions(+)
diff --git a/Documentation/devicetree/bindings/pci/pci.txt b/Documentation/devicetree/bindings/pci/pci.txt
index 2a5d91024059..29bcbd88f457 100644
--- a/Documentation/devicetree/bindings/pci/pci.txt
+++ b/Documentation/devicetree/bindings/pci/pci.txt
@@ -27,6 +27,11 @@ driver implementation may support the following properties:
- reset-gpios:
If present this property specifies PERST# GPIO. Host drivers can parse the
GPIO and apply fundamental reset to endpoints.
+- supports-clkreq:
+ If present this property specifies that CLKREQ signal routing exists from
+ root port to downstream device and host bridge drivers can do programming
+ which depends on CLKREQ signal existence. For example, programming root port
+ not to advertise ASPM L1 Sub-States support if there is no CLKREQ signal.
PCI-PCI Bridge properties
-------------------------
--
2.17.1
