On 7/10/2019 8:58 PM, Lorenzo Pieralisi wrote:
On Wed, Jul 10, 2019 at 11:52:08AM +0530, Vidya Sagar wrote:
Some host controllers need to know the existence of clkreq signal routing to
downstream devices to be able to advertise low power features like ASPM L1
substates. Without clkreq signal routing being present, enabling ASPM L1 sub
states might lead to downstream devices falling off the bus. Hence a new device
You mean "being disconnected from the bus" right ? I will update it.
Yes. I meant the same.
Lorenzo
tree property 'supports-clkreq' is added to make such host controllers
aware of clkreq signal routing to downstream devices.
Signed-off-by: Vidya Sagar <vidyas@xxxxxxxxxx>
Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
Reviewed-by: Thierry Reding <treding@xxxxxxxxxx>
---
V13:
* None
V12:
* Rebased on top of linux-next top of the tree
V11:
* None
V10:
* None
V9:
* None
V8:
* None
V7:
* None
V6:
* s/Documentation\/devicetree/dt-bindings/ in the subject
V5:
* None
V4:
* Rebased on top of linux-next top of the tree
V3:
* None
V2:
* This is a new patch in v2 series
Documentation/devicetree/bindings/pci/pci.txt | 5 +++++
1 file changed, 5 insertions(+)
diff --git a/Documentation/devicetree/bindings/pci/pci.txt b/Documentation/devicetree/bindings/pci/pci.txt
index 2a5d91024059..29bcbd88f457 100644
--- a/Documentation/devicetree/bindings/pci/pci.txt
+++ b/Documentation/devicetree/bindings/pci/pci.txt
@@ -27,6 +27,11 @@ driver implementation may support the following properties:
- reset-gpios:
If present this property specifies PERST# GPIO. Host drivers can parse the
GPIO and apply fundamental reset to endpoints.
+- supports-clkreq:
+ If present this property specifies that CLKREQ signal routing exists from
+ root port to downstream device and host bridge drivers can do programming
+ which depends on CLKREQ signal existence. For example, programming root port
+ not to advertise ASPM L1 Sub-States support if there is no CLKREQ signal.
PCI-PCI Bridge properties
-------------------------
--
2.17.1
