On Fri, May 17, 2019 at 11:08:50AM +0200, Rafael J. Wysocki wrote:
> From: Rafael J. Wysocki <rafael.j.wysocki@xxxxxxxxx>
>
> If a PCI driver leaves the device handled by it in D0 and calls
> pci_save_state() on the device in its ->suspend() or ->suspend_late()
> callback, it can expect the device to stay in D0 over the whole
> s2idle cycle. However, that may not be the case if there is a
> spurious wakeup while the system is suspended, because in that case
> pci_pm_suspend_noirq() will run again after pci_pm_resume_noirq()
> which calls pci_restore_state(), via pci_pm_default_resume_early(),
> so state_saved is cleared and the second iteration of
> pci_pm_suspend_noirq() will invoke pci_prepare_to_sleep() which
> may change the power state of the device.
>
> To avoid that, add a new internal flag, skip_bus_pm, that will be set
> by pci_pm_suspend_noirq() when it runs for the first time during the
> given system suspend-resume cycle if the state of the device has
> been saved already and the device is still in D0. Setting that flag
> will cause the next iterations of pci_pm_suspend_noirq() to set
> state_saved for pci_pm_resume_noirq(), so that it always restores the
> device state from the originally saved data, and avoid calling
> pci_prepare_to_sleep() for the device.
>
> Fixes: 33e4f80ee69b ("ACPI / PM: Ignore spurious SCI wakeups from suspend-to-idle")
> Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@xxxxxxxxx>
Reviewed-by: Mika Westerberg <mika.westerberg@xxxxxxxxxxxxxxx>
