Re: [PATCH V3 04/16] PCI: dwc: Perform dbi regs write lock towards the end

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, 17 Apr 2019 09:56:33 +0000 Gustavo Pimentel wrote:

> 
> On Tue, Apr 16, 2019 at 20:27:18, Vidya Sagar <vidyas@xxxxxxxxxx> wrote:
> 
> > Remove multiple write enable and disable sequences of dbi registers as
> > Tegra194 implements writes to BAR-0 register (offset: 0x10) controlled by
> > DBI write-lock enable bit thereby not allowing any further writes to BAR-0
> > register in config space to take place. Hence disabling write permission
> > only towards the end.
> >
> > Signed-off-by: Vidya Sagar <vidyas@xxxxxxxxxx>
> > ---
> > Changes since [v2]:
> > * None
> >
> > Changes since [v1]:
> > * None
> >
> >  drivers/pci/controller/dwc/pcie-designware-host.c | 3 ---
> >  1 file changed, 3 deletions(-)
> >
> > diff --git a/drivers/pci/controller/dwc/pcie-designware-host.c b/drivers/pci/controller/dwc/pcie-designware-host.c
> > index 2a5332e5ccfa..c0334c92c1a6 100644
> > --- a/drivers/pci/controller/dwc/pcie-designware-host.c
> > +++ b/drivers/pci/controller/dwc/pcie-designware-host.c
> > @@ -683,7 +683,6 @@ void dw_pcie_setup_rc(struct pcie_port *pp)
> >       val &= 0xffff00ff;
> >       val |= 0x00000100;
> >       dw_pcie_writel_dbi(pci, PCI_INTERRUPT_LINE, val);
> > -     dw_pcie_dbi_ro_wr_dis(pci);
> >
> >       /* Setup bus numbers */
> >       val = dw_pcie_readl_dbi(pci, PCI_PRIMARY_BUS);
> > @@ -723,8 +722,6 @@ void dw_pcie_setup_rc(struct pcie_port *pp)
> >
> >       dw_pcie_wr_own_conf(pp, PCI_BASE_ADDRESS_0, 4, 0);
> >
> > -     /* Enable write permission for the DBI read-only register */
> > -     dw_pcie_dbi_ro_wr_en(pci);
> >       /* Program correct class for RC */
> >       dw_pcie_wr_own_conf(pp, PCI_CLASS_DEVICE, 2, PCI_CLASS_BRIDGE_PCI);
> >       /* Better disable write permission right after the update */
> > --
> > 2.17.1  
> 
> This setup sequence was written by Jingoo Han, let's check if he did this
> by some particular reason.
> Jingoo do you remember why you wrote the code like this?

FWICT, enabling RO writeable in the setup sequence is introduced in
commit d91dfe5054d4 ("PCI: dwc: Enable write permission for Class Code, 
Interrupt Pin updates"). The Reason why not towards the end maybe
only enable the RO writeable when necessary.

thanks




[Index of Archives]     [DMA Engine]     [Linux Coverity]     [Linux USB]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Greybus]

  Powered by Linux