Make use of the 'warm reset' register to ensure every peace of
hardware (core, phy, endpoint card) are in a known state before doing
the hardware setup.
The Aardvark IP can trigger a reset signal upon hot reset or link
failure that will only reach the components on the board without
affecting the entire device (eg. only the endpoint card). This line is
multiplexed on MPPs so if it is not used as PCI reset and multiplexed
for instance as a GPIO, the signals produced by the PCIe IP during the
warm reset operation won't affect the state of the line.
As usual, hardware designers can implement a card reset wired to a
GPIO. Support for such reset GPIO will be added in another patch.
Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>
---
drivers/pci/controller/pci-aardvark.c | 17 +++++++++++++++++
1 file changed, 17 insertions(+)
diff --git a/drivers/pci/controller/pci-aardvark.c b/drivers/pci/controller/pci-aardvark.c
index 27ec79defa57..cfe48e553bca 100644
--- a/drivers/pci/controller/pci-aardvark.c
+++ b/drivers/pci/controller/pci-aardvark.c
@@ -139,6 +139,10 @@
#define CTRL_MODE_MASK 0x1
#define PCIE_CORE_MODE_DIRECT 0x0
#define PCIE_CORE_MODE_COMMAND 0x1
+#define CTRL_WARM_RESET_REG (CTRL_CORE_BASE_ADDR + 0x4)
+#define CTRL_PCIE_CORE_WARM_RESET BIT(0)
+#define CTRL_PHY_CORE_WARM_RESET BIT(1)
+#define CTRL_PERSTN_GPIO_EN BIT(3)
/* PCIe Central Interrupts Registers */
#define CENTRAL_INT_BASE_ADDR 0x1b000
@@ -249,6 +253,19 @@ static void advk_pcie_setup_hw(struct advk_pcie *pcie)
{
u32 reg;
+ /* Warm reset */
+ reg = advk_readl(pcie, CTRL_WARM_RESET_REG);
+ reg |= CTRL_PCIE_CORE_WARM_RESET | CTRL_PHY_CORE_WARM_RESET |
+ CTRL_PERSTN_GPIO_EN;
+ advk_writel(pcie, reg, CTRL_WARM_RESET_REG);
+ reg = advk_readl(pcie, CTRL_WARM_RESET_REG);
+ mdelay(1);
+ reg &= ~(CTRL_PCIE_CORE_WARM_RESET | CTRL_PHY_CORE_WARM_RESET |
+ CTRL_PERSTN_GPIO_EN);
+ advk_writel(pcie, reg, CTRL_WARM_RESET_REG);
+ reg = advk_readl(pcie, CTRL_WARM_RESET_REG);
+ mdelay(10);
+
/* Set HW Reference Clock Buffer Control */
advk_writel(pcie, PCIE_PHY_REFCLK_BUF_CTRL, PCIE_PHY_REFCLK);
--
2.19.1
