On Thu, May 24, 2018 at 04:36:24PM +0200, Marek Vasut wrote:
> If anything fails past phy_init_fn() and the system is a Gen3 with
> a PHY, the PHY will be left on and inited. This is caused by the
> phy_init_fn, which is in fact a pointer to rcar_pcie_phy_init_gen3()
> function, which starts the PHY, yet has no counterpart in the failpath.
> Add that counterpart.
>
> Signed-off-by: Marek Vasut <marek.vasut+renesas@xxxxxxxxx>
> Cc: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
> Cc: Lorenzo Pieralisi <lorenzo.pieralisi@xxxxxxx>
> Cc: Phil Edworthy <phil.edworthy@xxxxxxxxxxx>
> Cc: Simon Horman <horms+renesas@xxxxxxxxxxxx>
> Cc: Wolfram Sang <wsa@xxxxxxxxxxxxx>
> Cc: linux-renesas-soc@xxxxxxxxxxxxxxx
> Fixes: 517ca93a7159 ("PCI: rcar: Add R-Car gen3 PHY support")
> ---
> V4: New patch
> ---
> drivers/pci/host/pcie-rcar.c | 10 ++++++++--
> 1 file changed, 8 insertions(+), 2 deletions(-)
Applied to pci/controller-fixes to be tentatively merged at -rc4,
thanks.
Lorenzo
> diff --git a/drivers/pci/host/pcie-rcar.c b/drivers/pci/host/pcie-rcar.c
> index 636c3c5095d2..695781934f0a 100644
> --- a/drivers/pci/host/pcie-rcar.c
> +++ b/drivers/pci/host/pcie-rcar.c
> @@ -1163,7 +1163,7 @@ static int rcar_pcie_probe(struct platform_device *pdev)
> if (rcar_pcie_hw_init(pcie)) {
> dev_info(dev, "PCIe link down\n");
> err = -ENODEV;
> - goto err_clk_disable;
> + goto err_phy_shutdown;
> }
>
> data = rcar_pci_read_reg(pcie, MACSR);
> @@ -1175,7 +1175,7 @@ static int rcar_pcie_probe(struct platform_device *pdev)
> dev_err(dev,
> "failed to enable MSI support: %d\n",
> err);
> - goto err_clk_disable;
> + goto err_phy_shutdown;
> }
> }
>
> @@ -1189,6 +1189,12 @@ static int rcar_pcie_probe(struct platform_device *pdev)
> if (IS_ENABLED(CONFIG_PCI_MSI))
> rcar_pcie_teardown_msi(pcie);
>
> +err_phy_shutdown:
> + if (pcie->phy) {
> + phy_power_off(pcie->phy);
> + phy_exit(pcie->phy);
> + }
> +
> err_clk_disable:
> clk_disable_unprepare(pcie->bus_clk);
>
> --
> 2.16.2
>
