Re: [PATCH 5/5] Documentation/PCI: Add details of PCI AER statistics

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi,

On Tue, May 22, 2018 at 3:52 PM, Alex G. <mr.nuke.me@xxxxxxxxx> wrote:
> On 05/22/2018 05:28 PM, Rajat Jain wrote:
>> Add the PCI AER statistics details to
>> Documentation/PCI/pcieaer-howto.txt
>>
>> Signed-off-by: Rajat Jain <rajatja@xxxxxxxxxx>
>> ---
>>  Documentation/PCI/pcieaer-howto.txt | 35 +++++++++++++++++++++++++++++
>>  1 file changed, 35 insertions(+)
>>
>> diff --git a/Documentation/PCI/pcieaer-howto.txt b/Documentation/PCI/pcieaer-howto.txt
>> index acd0dddd6bb8..86ee9f9ff5e1 100644
>> --- a/Documentation/PCI/pcieaer-howto.txt
>> +++ b/Documentation/PCI/pcieaer-howto.txt
>> @@ -73,6 +73,41 @@ In the example, 'Requester ID' means the ID of the device who sends
>>  the error message to root port. Pls. refer to pci express specs for
>>  other fields.
>>
>> +2.4 AER statistics
>> +
>> +When AER messages are captured, the statistics are exposed via the following
>> +sysfs attributes under the "aer_stats" folder for the device:
>> +
>> +2.4.1 Device sysfs Attributes
>> +
>> +These attributes show up under all the devices that are AER capable. These
>> +indicate the errors "as seen by the device". Note that this may mean that if
>> +an end point is causing problems, the AER counters may increment at its link
>> +partner (e.g. root port) because the errors will be "seen" by the link partner
>> +and not the the problematic end point itself (which may report all counters
>> +as 0 as it never saw any problems).
>
> I was afraid of that. Is there a way to look at the requester ID to log
> AER errors to the correct device?

I do not think it is possible to pin point the source of the problem.
Errors may be caused due to sub optimal link tuning, or signal
integrity, or either of the link partners. Both the link partners will
detect and report the errors that they "see".

The bits and errors defined by the PCIe spec, follow the same semantics i.e.
 => the spec defines the different error conditions "as
seen/encountered by the device",
       => Thus the device reports those errors to the root port
               => which is what we are counting and reporting here.

IMHO, any interpretation / analysis of this error data / counters
should be left to the user so that he can look at different devices
and the errors they see, and then conclude on what might be the
problem.

Thanks,
Rajat

>
> Alex



[Index of Archives]     [DMA Engine]     [Linux Coverity]     [Linux USB]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Greybus]

  Powered by Linux