Tegra186 PCIe controller DT properties has couple of differences
wrt Tegra210 PCIe, rest of the DT properties are same.
Signed-off-by: Manikanta Maddireddy <mmaddireddy@xxxxxxxxxx>
---
.../bindings/pci/nvidia,tegra20-pcie.txt | 134 ++++++++++++++++++++-
1 file changed, 130 insertions(+), 4 deletions(-)
diff --git a/Documentation/devicetree/bindings/pci/nvidia,tegra20-pcie.txt b/Documentation/devicetree/bindings/pci/nvidia,tegra20-pcie.txt
index 982a74ea6df9..753b67327373 100644
--- a/Documentation/devicetree/bindings/pci/nvidia,tegra20-pcie.txt
+++ b/Documentation/devicetree/bindings/pci/nvidia,tegra20-pcie.txt
@@ -1,10 +1,15 @@
NVIDIA Tegra PCIe controller
Required properties:
-- compatible: For Tegra20, must contain "nvidia,tegra20-pcie". For Tegra30,
- "nvidia,tegra30-pcie". For Tegra124, must contain "nvidia,tegra124-pcie".
- Otherwise, must contain "nvidia,<chip>-pcie", plus one of the above, where
- <chip> is tegra132 or tegra210.
+- compatible: Must be:
+ - "nvidia,tegra20-pcie": for Tegra20
+ - "nvidia,tegra30-pcie": for Tegra30
+ - "nvidia,tegra124-pcie": for Tegra124 and Tegra132
+ - "nvidia,tegra210-pcie": for Tegra210
+ - "nvidia,tegra186-pcie": for Tegra186
+- power-domains: To ungate power partition by BPMP powergate driver. Must
+contain BPMP phandle and PCIe power partition ID. This is required only
+for Tegra186.
- device_type: Must be "pci"
- reg: A list of physical base address and length for each set of controller
registers. Must contain an entry for each entry in the reg-names property.
@@ -124,6 +129,16 @@ Power supplies for Tegra210:
- vddio-pex-ctl-supply: Power supply for PCIe control I/O partition. Must
supply 1.8 V.
+Power supplies for Tegra186:
+- Required:
+ - dvdd-pex-supply: Power supply for digital PCIe I/O. Must supply 1.05 V.
+ - hvdd-pex-pll-supply: High-voltage supply for PLLE (shared with USB3). Must
+ supply 1.8 V.
+ - hvdd-pex-supply: High-voltage supply for PCIe I/O and PCIe output clocks.
+ Must supply 1.8 V.
+ - vddio-pexctl-aud-supply: Power supply for PCIe side band signals. Must
+ supply 1.8 V.
+
Root ports are defined as subnodes of the PCIe controller node.
Required properties:
@@ -546,3 +561,114 @@ Board DTS:
status = "okay";
};
};
+
+Tegra186:
+---------
+
+SoC DTSI:
+
+ pcie@10003000 {
+ compatible = "nvidia,tegra186-pcie";
+ power-domains = <&bpmp TEGRA186_POWER_DOMAIN_PCX>;
+ device_type = "pci";
+ reg = <0x0 0x10003000 0x0 0x00000800 /* PADS registers */
+ 0x0 0x10003800 0x0 0x00000800 /* AFI registers */
+ 0x0 0x40000000 0x0 0x10000000>; /* configuration space */
+ reg-names = "pads", "afi", "cs";
+
+ interrupts = <GIC_SPI 72 IRQ_TYPE_LEVEL_HIGH>, /* controller interrupt */
+ <GIC_SPI 73 IRQ_TYPE_LEVEL_HIGH>; /* MSI interrupt */
+ interrupt-names = "intr", "msi";
+
+ #interrupt-cells = <1>;
+ interrupt-map-mask = <0 0 0 0>;
+ interrupt-map = <0 0 0 0 &gic GIC_SPI 72 IRQ_TYPE_LEVEL_HIGH>;
+
+ bus-range = <0x00 0xff>;
+ #address-cells = <3>;
+ #size-cells = <2>;
+
+ ranges = <0x82000000 0 0x10000000 0x0 0x10000000 0 0x00001000 /* port 0 configuration space */
+ 0x82000000 0 0x10001000 0x0 0x10001000 0 0x00001000 /* port 1 configuration space */
+ 0x82000000 0 0x10004000 0x0 0x10004000 0 0x00001000 /* port 2 configuration space */
+ 0x81000000 0 0x0 0x0 0x50000000 0 0x00010000 /* downstream I/O (64 KiB) */
+ 0x82000000 0 0x50100000 0x0 0x50100000 0 0x07F00000 /* non-prefetchable memory (127 MiB) */
+ 0xc2000000 0 0x58000000 0x0 0x58000000 0 0x28000000>; /* prefetchable memory (640 MiB) */
+
+ clocks = <&bpmp TEGRA186_CLK_AFI>,
+ <&bpmp TEGRA186_CLK_PCIE>,
+ <&bpmp TEGRA186_CLK_PLLE>;
+ clock-names = "afi", "pex", "pll_e";
+
+ resets = <&bpmp TEGRA186_RESET_AFI>,
+ <&bpmp TEGRA186_RESET_PCIE>,
+ <&bpmp TEGRA186_RESET_PCIEXCLK>;
+ reset-names = "afi", "pex", "pcie_x";
+
+ status = "disabled";
+
+ pci@1,0 {
+ device_type = "pci";
+ assigned-addresses = <0x82000800 0 0x10000000 0 0x1000>;
+ reg = <0x000800 0 0 0 0>;
+ status = "disabled";
+
+ #address-cells = <3>;
+ #size-cells = <2>;
+ ranges;
+
+ nvidia,num-lanes = <2>;
+ };
+
+ pci@2,0 {
+ device_type = "pci";
+ assigned-addresses = <0x82001000 0 0x10001000 0 0x1000>;
+ reg = <0x001000 0 0 0 0>;
+ status = "disabled";
+
+ #address-cells = <3>;
+ #size-cells = <2>;
+ ranges;
+
+ nvidia,num-lanes = <1>;
+ };
+
+ pci@3,0 {
+ device_type = "pci";
+ assigned-addresses = <0x82001800 0 0x10004000 0 0x1000>;
+ reg = <0x001800 0 0 0 0>;
+ status = "disabled";
+
+ #address-cells = <3>;
+ #size-cells = <2>;
+ ranges;
+
+ nvidia,num-lanes = <1>;
+ };
+ };
+
+Board DTS:
+
+ pcie@10003000 {
+ status = "okay";
+
+ dvdd-pex-supply = <&vdd_pex>;
+ hvdd-pex-pll-supply = <&vdd_1v8>;
+ hvdd-pex-supply = <&vdd_1v8>;
+ vddio-pexctl-aud-supply = <&vdd_1v8>;
+
+ pci@1,0 {
+ nvidia,num-lanes = <4>;
+ status = "okay";
+ };
+
+ pci@2,0 {
+ nvidia,num-lanes = <0>;
+ status = "disabled";
+ };
+
+ pci@3,0 {
+ nvidia,num-lanes = <1>;
+ status = "disabled";
+ };
+ };
--
2.1.4
