Deprecate legacy PHY model and encourage to use per-lane PHY
model.
Signed-off-by: Shawn Lin <shawn.lin@xxxxxxxxxxxxxx>
---
.../devicetree/bindings/pci/rockchip-pcie.txt | 25 ++++++++++++++++++++--
1 file changed, 23 insertions(+), 2 deletions(-)
diff --git a/Documentation/devicetree/bindings/pci/rockchip-pcie.txt b/Documentation/devicetree/bindings/pci/rockchip-pcie.txt
index 1453a73..78d4469 100644
--- a/Documentation/devicetree/bindings/pci/rockchip-pcie.txt
+++ b/Documentation/devicetree/bindings/pci/rockchip-pcie.txt
@@ -19,8 +19,6 @@ Required properties:
- "pm"
- msi-map: Maps a Requester ID to an MSI controller and associated
msi-specifier data. See ./pci-msi.txt
-- phys: From PHY bindings: Phandle for the Generic PHY for PCIe.
-- phy-names: MUST be "pcie-phy".
- interrupts: Three interrupt entries must be specified.
- interrupt-names: Must include the following names
- "sys"
@@ -42,6 +40,18 @@ Required properties:
interrupt source. The value must be 1.
- interrupt-map-mask and interrupt-map: standard PCI properties
+Required properties for legacy PHY model (deprecated):
+- phys: From PHY bindings: Phandle for the Generic PHY for PCIe.
+- phy-names: MUST be "pcie-phy".
+
+Required properties for per-lane PHY model:
+- phys: Must contain an phandle to a PHY for each entry in phy-names.
+- phy-names: Must include an entry for each active lane. Note that the number
+ of entries does not have to (though usually will) be equal to the specified
+ number of lanes in the num-lanes property. Entries are of the form
+ "pcie-phy-N": where N ranges from 0 to the value specified of (num-lanes - 1).
+ (see example below)
+
Optional Property:
- aspm-no-l0s: RC won't support ASPM L0s. This property is needed if
using 24MHz OSC for RC's PHY.
@@ -95,6 +105,7 @@ pcie0: pcie@f8000000 {
<&cru SRST_PCIE_PM>, <&cru SRST_P_PCIE>, <&cru SRST_A_PCIE>;
reset-names = "core", "mgmt", "mgmt-sticky", "pipe",
"pm", "pclk", "aclk";
+ /* deprecated legacy PHY model */
phys = <&pcie_phy>;
phy-names = "pcie-phy";
pinctrl-names = "default";
@@ -111,3 +122,13 @@ pcie0: pcie@f8000000 {
#interrupt-cells = <1>;
};
};
+
+pcie0: pcie@f8000000 {
+ ...
+
+ /* preferred per-lane PHY model */
+ phys = <&pcie_phy 0>, <&pcie_phy 1>, <&pcie_phy 2>, <&pcie_phy 3>;
+ phy-names = "pcie-phy-0", "pcie-phy-1", "pcie-phy-2", "pcie-phy-3";
+
+ ...
+};
--
1.9.1
