On Thu, 15 Jun 2017, Kai-Heng Feng wrote: > On Wed, Jun 14, 2017 at 1:28 AM, Bjorn Helgaas <helgaas@xxxxxxxxxx> wrote: > > > > The lspci output [1] shows: > > > > 00:12.0 USB controller: Advanced Micro Devices, Inc. [AMD] FCH USB EHCI Controller (rev 39) (prog-if 20 [EHCI]) > > Capabilities: [c0] Power Management version 2 > > Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+) > > Status: D3 NoSoftRst- PME-Enable+ DSel=0 DScale=0 PME- > > Bridge: PM- B3+ > > > > The device claims it can assert PME# from D3hot. If it can't, that > > sounds like a hardware defect that should be addressed with a quirk. > > Ideally we would also have a pointer to the AMD hardware erratum. > > Looks like it's pretty similar to "23 USB Wake on Connect/Disconnect > with Low Speed Devices" in [1]. > It points to a workaround in appendix A2 from [2]. > However it says this bug only effects Low Speed devices, but it > actually also happens on High Speed devices. > > [1] https://support.amd.com/TechDocs/46837.pdf > [2] https://support.amd.com/TechDocs/42413.pdf Those documents refer to a hardware bug with a workaround in the BIOS. Have you checked to see if your BIOS is up to date? Alan Stern
