For Configuration Requests only, following reset
it is possible for a device to terminate the request
but indicate that it is temporarily unable to process
the Request, but will be able to process the Request
in the future – in this case, the Configuration Request
Retry Status 10 (CRS) Completion Status is used
SPDK user space NVMe driver reinitializes NVMe which
causes reset, while doing this some configuration requests
get NAKed by Endpoint (NVMe).
Current iproc PCI driver is agnostic about it.
PAXB will forward the NAKed response in stipulated AXI code.
NVMe spec defines this timeout in 500 ms units, and this
only happens if controller has been in reset, or with new firmware,
or in abrupt shutdown case.
Meanwhile config access could result into retry.
This patch fixes the problem, and attempts to read again in case
of PAXB forwarding the NAK.
It implements iproc_pcie_config_read which gets called for Stingray.
Otherwise it falls back to PCI generic APIs.
Signed-off-by: Oza Pawandeep <oza.oza@xxxxxxxxxxxx>
Reviewed-by: Ray Jui <ray.jui@xxxxxxxxxxxx>
Reviewed-by: Scott Branden <scott.branden@xxxxxxxxxxxx>
diff --git a/drivers/pci/host/pcie-iproc.c b/drivers/pci/host/pcie-iproc.c
index 0f39bd2..05a3647 100644
--- a/drivers/pci/host/pcie-iproc.c
+++ b/drivers/pci/host/pcie-iproc.c
@@ -68,6 +68,9 @@
#define APB_ERR_EN_SHIFT 0
#define APB_ERR_EN BIT(APB_ERR_EN_SHIFT)
+#define CFG_RETRY_STATUS 0xffff0001
+#define CFG_RETRY_STATUS_TIMEOUT_US 500000 /* 500 milli-seconds. */
+
/* derive the enum index of the outbound/inbound mapping registers */
#define MAP_REG(base_reg, index) ((base_reg) + (index) * 2)
@@ -448,6 +451,47 @@ static inline void iproc_pcie_apb_err_disable(struct pci_bus *bus,
}
}
+static int iproc_pcie_cfg_retry(void __iomem *cfg_data_p)
+{
+ int timeout = CFG_RETRY_STATUS_TIMEOUT_US;
+ unsigned int ret;
+
+ do {
+ ret = readl(cfg_data_p);
+ if (ret == CFG_RETRY_STATUS)
+ udelay(1);
+ else
+ return PCIBIOS_SUCCESSFUL;
+ } while (timeout--);
+
+ return PCIBIOS_DEVICE_NOT_FOUND;
+}
+
+static void __iomem *iproc_pcie_map_ep_cfg_reg(struct iproc_pcie *pcie,
+ unsigned int busno,
+ unsigned int slot,
+ unsigned int fn,
+ int where)
+{
+ u16 offset;
+ u32 val;
+
+ /* EP device access */
+ val = (busno << CFG_ADDR_BUS_NUM_SHIFT) |
+ (slot << CFG_ADDR_DEV_NUM_SHIFT) |
+ (fn << CFG_ADDR_FUNC_NUM_SHIFT) |
+ (where & CFG_ADDR_REG_NUM_MASK) |
+ (1 & CFG_ADDR_CFG_TYPE_MASK);
+
+ iproc_pcie_write_reg(pcie, IPROC_PCIE_CFG_ADDR, val);
+ offset = iproc_pcie_reg_offset(pcie, IPROC_PCIE_CFG_DATA);
+
+ if (iproc_pcie_reg_is_invalid(offset))
+ return NULL;
+
+ return (pcie->base + offset);
+}
+
/**
* Note access to the configuration registers are protected at the higher layer
* by 'pci_lock' in drivers/pci/access.c
@@ -499,13 +543,48 @@ static void __iomem *iproc_pcie_map_cfg_bus(struct pci_bus *bus,
return (pcie->base + offset);
}
+static int iproc_pcie_config_read(struct pci_bus *bus, unsigned int devfn,
+ int where, int size, u32 *val)
+{
+ struct iproc_pcie *pcie = iproc_data(bus);
+ unsigned int slot = PCI_SLOT(devfn);
+ unsigned int fn = PCI_FUNC(devfn);
+ unsigned int busno = bus->number;
+ void __iomem *cfg_data_p;
+ int ret;
+
+ /* root complex access. */
+ if (busno == 0)
+ return pci_generic_config_read32(bus, devfn, where, size, val);
+
+ cfg_data_p = iproc_pcie_map_ep_cfg_reg(pcie, busno, slot, fn, where);
+
+ if (!cfg_data_p)
+ return PCIBIOS_DEVICE_NOT_FOUND;
+
+ ret = iproc_pcie_cfg_retry(cfg_data_p);
+ if (ret)
+ return ret;
+
+ *val = readl(cfg_data_p);
+
+ if (size <= 2)
+ *val = (*val >> (8 * (where & 3))) & ((1 << (size * 8)) - 1);
+
+ return PCIBIOS_SUCCESSFUL;
+}
+
static int iproc_pcie_config_read32(struct pci_bus *bus, unsigned int devfn,
int where, int size, u32 *val)
{
int ret;
+ struct iproc_pcie *pcie = iproc_data(bus);
iproc_pcie_apb_err_disable(bus, true);
- ret = pci_generic_config_read32(bus, devfn, where, size, val);
+ if (pcie->type == IPROC_PCIE_PAXB_V2)
+ ret = iproc_pcie_config_read(bus, devfn, where, size, val);
+ else
+ ret = pci_generic_config_read32(bus, devfn, where, size, val);
iproc_pcie_apb_err_disable(bus, false);
return ret;
--
1.9.1
