On Mon, Dec 12, 2016 at 07:51:27PM +0800, Shawn Lin wrote:
> Rockchip's RC outputs 100MHz reference clock but there are
> two methods for PHY to generate it.
>
> (1)One of them is to use system PLL to generate 100MHz clock and
> the PHY will relock it and filter signal noise then outputs the
> reference clock.
>
> (2)Another way is to share Soc's 24MHZ crystal oscillator with
> PHY and force PHY's DLL to generate 100MHz internally.
>
> When using case(2), the exit from L0s doesn't work fine occasionally
> due to the broken design of RC receiver's logical circuit. So even if
> we use extended-synch, it still fails for PHY to relock the bits from
> FTS sometimes. This will hang the system.
>
> Maybe we could argue that why not use case(1) to avoid it? The reason
> is that as we could see the reference clock is derived from system PLL
> and the path from it to PHY isn't so clean which means there are some
> noise introduced by power-domain and other buses can't be filterd out
> by PHY and we could see noise from the frequency spectrum by
> oscilloscope. This makes the TX compatibility test a little difficult
> to pass the spec. So case(1) and case(2) are both used indeed now. If
> using case(2), we should disable RC's L0s support, and that is why we
> need this property to indicate this quirk.
>
> Also after checking quirk.c, I noticed there is already a quirk for
> disabling L0s unconditionally, quirk_disable_aspm_l0s. But obviously we
> shouldn't do that as mentioned above that case(1) could still works fine
> with L0s.
>
> Reported-by: Jeffy Chen <jeffy.chen@xxxxxxxxxxxxxx>
> Cc: Brian Norris <briannorris@xxxxxxxxxxxx>
> Signed-off-by: Shawn Lin <shawn.lin@xxxxxxxxxxxxxx>
>
> ---
>
> Changes in v2:
> - drop the quirk prefix
>
> Documentation/devicetree/bindings/pci/rockchip-pcie.txt | 2 ++
> drivers/pci/host/pcie-rockchip.c | 9 +++++++++
> 2 files changed, 11 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/pci/rockchip-pcie.txt b/Documentation/devicetree/bindings/pci/rockchip-pcie.txt
> index 71aeda1..1453a73 100644
> --- a/Documentation/devicetree/bindings/pci/rockchip-pcie.txt
> +++ b/Documentation/devicetree/bindings/pci/rockchip-pcie.txt
> @@ -43,6 +43,8 @@ Required properties:
> - interrupt-map-mask and interrupt-map: standard PCI properties
>
> Optional Property:
> +- aspm-no-l0s: RC won't support ASPM L0s. This property is needed if
> + using 24MHz OSC for RC's PHY.
> - ep-gpios: contain the entry for pre-reset gpio
> - num-lanes: number of lanes to use
> - vpcie3v3-supply: The phandle to the 3.3v regulator to use for PCIe.
> diff --git a/drivers/pci/host/pcie-rockchip.c b/drivers/pci/host/pcie-rockchip.c
> index f2dca7b..35988fc 100644
> --- a/drivers/pci/host/pcie-rockchip.c
> +++ b/drivers/pci/host/pcie-rockchip.c
> @@ -140,6 +140,8 @@
> #define PCIE_RC_CONFIG_DCR_CSPL_SHIFT 18
> #define PCIE_RC_CONFIG_DCR_CSPL_LIMIT 0xff
> #define PCIE_RC_CONFIG_DCR_CPLS_SHIFT 26
> +#define PCIE_RC_CONFIG_LINK_CAP (PCIE_RC_CONFIG_BASE + 0xcc)
> +#define PCIE_RC_CONFIG_LINK_CAP_L0S BIT(10)
> #define PCIE_RC_CONFIG_LCS (PCIE_RC_CONFIG_BASE + 0xd0)
> #define PCIE_RC_CONFIG_L1_SUBSTATE_CTRL2 (PCIE_RC_CONFIG_BASE + 0x90c)
> #define PCIE_RC_CONFIG_THP_CAP (PCIE_RC_CONFIG_BASE + 0x274)
> @@ -653,6 +655,13 @@ static int rockchip_pcie_init_port(struct rockchip_pcie *rockchip)
> status &= ~PCIE_RC_CONFIG_THP_CAP_NEXT_MASK;
> rockchip_pcie_write(rockchip, status, PCIE_RC_CONFIG_THP_CAP);
>
> + /* Clear L0s from RC's link cap */
> + if (of_property_read_bool(dev->of_node, "apsm-no-l0s")) {
Did you test this? This string ("apsm-no-l0s") doesn't match the
"aspm-no-l0s" documented above. The current tree doesn't contain either
string in any DTS.
> + status = rockchip_pcie_read(rockchip, PCIE_RC_CONFIG_LINK_CAP);
> + status &= ~PCIE_RC_CONFIG_LINK_CAP_L0S;
> + rockchip_pcie_write(rockchip, status, PCIE_RC_CONFIG_LINK_CAP);
> + }
> +
> rockchip_pcie_write(rockchip, 0x0, PCIE_RC_BAR_CONF);
>
> rockchip_pcie_write(rockchip,
> --
> 1.9.1
>
>
> --
> To unsubscribe from this list: send the line "unsubscribe linux-pci" in
> the body of a message to majordomo@xxxxxxxxxxxxxxx
> More majordomo info at http://vger.kernel.org/majordomo-info.html
--
To unsubscribe from this list: send the line "unsubscribe linux-pci" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
